Hitachi, Ltd.
Hitachi, Ltd. SRP-2600 DT00471 250W Projector Lamp
A 250 W replacement lamp module with bulb and housing ready for installation, rated for 2,000 hours of use
- TypeProjector Lamp
- Wattage250W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled bulb and housing
- 250W UHB lamp delivers specified brightness
- 2,000-hour rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Genuine OEM components from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita
Replacement lamp module for Hitachi projectors
The Hitachi SRP-2600 DT00471 is a new 250W projector lamp supplied as a complete bulb-and-housing assembly. It is intended for owners of compatible Hitachi projectors who need a direct replacement without additional assembly steps.
Moves from a dimmed or expired original lamp
The module restores brightness when the factory lamp reaches its 2000-hour rated life or fails earlier. The jump is worth it when image quality has dropped enough to affect presentations or viewing comfort and a full housing swap is preferred over bare-bulb handling.
Fits into the projector’s existing lamp compartment
The pre-assembled unit slides into the same slot as the original, requiring no separate bulb alignment or housing reuse. It frees up maintenance time by eliminating the need to transfer the old bulb into a reused cage.
Highlights
- Ready to install with pre-assembled bulb and housing
- 250W UHB lamp delivers specified brightness
- 2,000-hour rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Genuine OEM components from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 250W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the SRP-2600 DT00471 lamp module include the housing so it fits directly into my Hitachi projector?
Yes, the module is supplied as a fully assembled 250W UHB bulb inside its housing, ready to slide into the projector lamp compartment without extra parts.
What is the correct installation sequence for the SRP-2600 lamp, and which step is most often missed?
Power off and unplug the projector, let it cool, remove the lamp cover, release the retaining screws, pull out the old module, insert the new DT00471 unit until it seats firmly, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most often forgotten.
When will the 250W UHB bulb in the SRP-2600 need replacement based on its rated life?
The lamp is rated for 2,000 hours of use; plan to replace the module once the projector's hour counter approaches that figure or when brightness noticeably drops.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



