Hitachi, Ltd.
Hitachi, Ltd. HCP-K26 Projector Lamp 225W DT01511
A 225W replacement projector lamp module with a fully assembled bulb and housing for easy installation, rated for 4,500 to 6,000 hours of use
- TypeProjector Lamp
- Wattage225W
- Lamp Life4,500 (Normal) - 6,000 (Economy) Hrs.
- Genuine Philips UHP 225W bulb delivers reliable brightness
- Pre-assembled housing enables quick tool-free installation
- Up to 6000 hours life in economy mode
- Manufactured under ISO 9001 quality standards
- Compatible with Hitachi DT01511 projector models
Ready-to-install lamp module
The Hitachi HCP-K26 projector lamp arrives as a complete 225 W bulb-and-housing assembly. It fits directly into compatible Hitachi projectors without additional tools or alignment steps. Installers can swap the module and resume operation immediately.
225 W UHP lamp
The lamp uses a Philips UHP bulb rated at 225 watts, matching the original projector specification. Brightness, colour balance and ignition voltage remain consistent with the factory-installed unit. This wattage is the single figure that confirms correct replacement.
4,500 to 6,000 hour service life
In normal mode the lamp delivers approximately 4,500 hours of projection time. Switching to economy mode extends the rated life to around 6,000 hours for less demanding presentations. Heavy daily use will reach the limit sooner, while occasional use provides years of headroom.
Highlights
- Genuine Philips UHP 225W bulb delivers reliable brightness
- Pre-assembled housing enables quick tool-free installation
- Up to 6000 hours life in economy mode
- Manufactured under ISO 9001 quality standards
- Compatible with Hitachi DT01511 projector models
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 225W |
| Lamp Life | 4,500 (Normal) - 6,000 (Economy) Hrs. |
Questions about this item
How many hours of use will the 225W UHP bulb deliver in normal and economy modes?
The lamp is rated for 4,500 hours in normal mode and 6,000 hours in economy mode, giving a clear expectation of replacement intervals.
Does the HCP-K26 module use a standard lamp interface that limits compatibility to specific Hitachi models?
It is a direct replacement module built to the original DT01511 specification, so it fits only the Hitachi projectors designed for that part number.
What physical space is required to install the assembled bulb-and-housing unit?
The module matches the factory housing dimensions for the HCP-K26 series, sliding into the projector’s lamp bay without adapters or modifications.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



