Hitachi, Ltd.
Hitachi, Ltd. HCP-76X Projector Lamp 160W 2,000 Hrs
A 160 watt replacement lamp module with 2,000 hour life, supplied as a complete housing for straightforward installation
- TypeProjector Lamp
- Wattage160W
- Lamp Life2,000 Hrs.
- Ready-to-install module saves setup time
- 160W UHB bulb matches original brightness
- 2,000-hour rated life extends replacement interval
- ISO 9001 manufacturing ensures consistent quality
- Compatible with Hitachi DT00781 projectors
Replacement lamp module for Hitachi projectors
This new projector lamp module combines a 160 W UHB bulb with its housing so it fits directly into compatible Hitachi models. The assembly arrives fully assembled and ready for tool-free installation. It is intended for owners of Hitachi projectors that specify the HCP-76X or DT00781 part number.
Upgrades from a dim or expired original lamp
When the factory lamp reaches its 2 000-hour rated life or brightness drops below usable levels, this module restores original output without modifying the projector. The jump is worth it when image quality has faded or the projector warns that lamp replacement is due. Buyers who need a higher-wattage or longer-life alternative cannot use this module.
Check the projector model
Verify that your Hitachi projector lists HCP-76X or DT00781 as the approved lamp type in its manual or on the existing lamp label. Confirm the projector accepts a 160 W UHB lamp and that the housing matches the installed module. Installing this lamp in an unlisted model may cause fit or ignition problems.
Highlights
- Ready-to-install module saves setup time
- 160W UHB bulb matches original brightness
- 2,000-hour rated life extends replacement interval
- ISO 9001 manufacturing ensures consistent quality
- Compatible with Hitachi DT00781 projectors
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 160W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the HCP-76X lamp module include the housing so it fits the DT00781 slot directly?
Yes, the module is supplied as a fully assembled 160 W bulb inside its housing, matching the DT00781 form factor for direct installation.
What is the correct sequence to install the lamp without triggering a reset error?
Power off the projector, unplug it, wait for cooling, remove the lamp cover, swap the module, replace the cover, then reset the lamp timer in the menu.
When should the 160 W UHB bulb be replaced based on its rated life?
Plan replacement around 2,000 hours of use; the projector’s lamp-hour counter will show the exact elapsed time.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



