Hitachi, Ltd. HCP-3560X Projector Lamp 210W

Ready-to-install 210 W lamp module

This Hitachi HCP-3560X lamp ships as a complete bulb-and-housing assembly so it fits straight into the projector without extra steps. The module uses a genuine Philips UHP 210 W bulb built to ISO 9001 quality checks for beam performance, ignition, voltage and run-time. Installation typically takes only a few minutes by following the projector's own lamp-replacement guide.

Easy swap with no alignment hassles

Because the bulb is pre-seated in its housing, there is no need to handle the bare lamp or adjust reflectors during installation. The most common issue is forgetting to reset the projector's lamp-hour counter after fitting the new module, which can leave the replacement warning active. Dust on the housing vents can also reduce airflow, so a quick blast of compressed air before closing the cover helps maintain rated life.

210 W output rated for 3 000 to 6 000 hours

In normal mode the lamp delivers its full 210 W brightness for about 3 000 hours, while economy mode extends the rating to roughly 6 000 hours at reduced output. Heavy daily use in normal mode will reach the rated limit sooner, and brightness will gradually decline as the lamp ages. The module is not suited for users who need significantly longer maintenance intervals or higher lumen output than the 210 W design provides.