Hitachi, Ltd.
Hitachi, Ltd. EDP-PJ32 Projector Lamp 165W 2000 Hrs
A new 165 W projector lamp module with a 2 000-hour rated life, supplied as a complete housing for direct installation
- TypeProjector Lamp
- Wattage165W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled housing
- 165 W Philips UHB lamp delivers bright output
- Rated 2000 hours of projection time
- Manufactured under ISO 9001 quality controls
- OEM-compatible module fits Hitachi projectors
Replacement Lamp for Hitachi EDP-PJ32
The Hitachi EDP-PJ32 is a new 165W projector lamp module with a Philips UHB bulb inside a ready-to-fit housing. Rated at 2,000 hours, it restores original brightness to compatible Hitachi projectors without additional assembly.
Ideal for Direct Replacement, Not for Other Models
This lamp suits owners of Hitachi projectors that specify the EDP-PJ32 or DT00701 part who need a drop-in module. It does not suit buyers who need a different wattage, a bare bulb without housing, or a lamp coded for another projector series.
165W Philips UHB Bulb with 2,000-Hour Rating
The single deciding specification is the 165W UHB lamp rated for 2,000 hours of use. Match this wattage and life figure to the projector's service manual before ordering to confirm compatibility.
Highlights
- Ready to install with pre-assembled housing
- 165 W Philips UHB lamp delivers bright output
- Rated 2000 hours of projection time
- Manufactured under ISO 9001 quality controls
- OEM-compatible module fits Hitachi projectors
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 165W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Which Hitachi projectors accept the EDP-PJ32 lamp module?
The EDP-PJ32 module (Hitachi part DT00701) is built as a direct replacement for Hitachi projectors that specify this lamp code; check your projector's manual for the EDP-PJ32 designation before ordering.
Will the 165W UHB bulb in this module match the brightness and ignition timing of the original lamp in my older Hitachi projector?
Yes — the module uses a new Philips UHB 165W bulb built to ISO9001 standards, so its output and start-up behaviour are calibrated to the same specifications as the factory lamp.
How can I confirm the lamp is running correctly after I install it?
After installation, reset the projector's lamp-hour counter; the new module is rated for 2,000 hours of operation, so the counter should begin counting from zero and the image should reach full brightness without flickering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



