Hitachi, Ltd.
Hitachi, Ltd. ED-X15 Projector Lamp 200W 2000 Hrs
A 200 W replacement lamp module with 2,000-hour life for Hitachi projectors
- TypeProjector Lamp
- Wattage200W
- Lamp Life2,000 Hrs.
- Genuine compatible replacement lamp ready for easy installation
- 200W UHB bulb delivers bright projection
- 2,000 hours rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi ED-X15 projector model DT00757
Genuine Hitachi ED-X15 Replacement Lamp
This 200W UHB projector lamp module arrives fully assembled with bulb and housing for straightforward installation. It is built to ISO9001 standards and rated for 2000 hours of operation. Designed as a direct replacement for Hitachi projectors using the DT00757 lamp module.
For users needing a ready-to-fit 200W UHB module
Suitable for owners of compatible Hitachi projectors who want a complete lamp-and-housing unit without separate bulb handling. Not intended for projectors that require a different wattage, connector type, or bare-bulb replacement. Buyers whose devices specify an alternative lamp code should verify compatibility before purchasing.
200W UHB lamp rated for 2000 hours
The 200-watt ultra-high-pressure bulb delivers the specified brightness and 2000-hour service life for supported Hitachi models. This single figure determines whether the module matches the projector's optical and electrical requirements.
Highlights
- Genuine compatible replacement lamp ready for easy installation
- 200W UHB bulb delivers bright projection
- 2,000 hours rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi ED-X15 projector model DT00757
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 200W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Which Hitachi projector models accept the DT00757 lamp module?
The DT00757 module is built for the Hitachi ED-X15 projector, so that model must be the one you already own for the lamp to fit and operate correctly.
Will the 200W UHB lamp run in a projector that originally used a lower-wattage module?
The lamp is rated at 200W and 2,000 hours; it should only be used in a projector designed for that wattage, otherwise the power supply or cooling may not support it.
How can I confirm the new lamp is performing correctly after installation?
Reset the projector's lamp-hour counter, then verify the image reaches full brightness without flicker and that the counter begins tracking from zero hours.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



