Hitachi, Ltd.
Hitachi, Ltd. ED-X10 Projector Lamp DT00757 200W 2000 Hrs
An OEM replacement lamp with a Philips UHB 200 W bulb in a ready-to-fit housing, rated for 2,000 hours
- TypeProjector Lamp
- Wattage200W
- Lamp Life2,000 Hrs.
- Ready-to-install module with genuine Philips 200W UHB bulb
- 2000-hour rated lamp life for extended use
- Manufactured to ISO9001 quality standards
- Tested for beam performance, ignition and run-time
- Direct OEM replacement for Hitachi ED-X10 DT00757
Replacement Lamp for Hitachi ED-X10
This new projector lamp module fits the Hitachi ED-X10 and uses a 200 W Philips UHB bulb inside a complete housing. It is intended for owners of that projector who need a direct replacement when the original lamp reaches end of life. The unit arrives fully assembled and ready to install without extra tools.
Upgrade from a Dim or Expired Original Lamp
The module restores brightness and colour accuracy once the factory lamp has faded or failed after its rated 2,000 hours of use. Swapping is worthwhile when image quality drops noticeably or the projector warns that lamp hours are exceeded. No other projector models are supported by this specific DT00757 assembly.
Simple Housing Swap with Common Pitfalls
Installation requires opening the projector lamp door, removing the old housing and sliding the new module into place until it seats firmly. The most frequent issues are forgetting to reset the lamp-hour counter in the menu and touching the bulb glass with bare fingers, which can shorten the new lamp's life.
Highlights
- Ready-to-install module with genuine Philips 200W UHB bulb
- 2000-hour rated lamp life for extended use
- Manufactured to ISO9001 quality standards
- Tested for beam performance, ignition and run-time
- Direct OEM replacement for Hitachi ED-X10 DT00757
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 200W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the DT00757 housing match the Hitachi ED-X10 mounting points?
The module is a fully assembled bulb and housing designed for direct fit in the Hitachi ED-X10 projector.
What is the common mistake when installing this 200W lamp module?
Forgetting to reset the projector lamp-hour counter after fitting the new module.
How often must the 200W UHB bulb be replaced at 2,000-hour rated life?
Plan replacement after approximately 2,000 hours of use or when brightness drops noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



