Hitachi, Ltd.
Hitachi, Ltd. DT00751 Genuine Compatible Projector Lamp 165W 2000 Hrs
A new 165 W replacement lamp module with 2,000-hour rated life for Hitachi projectors
- TypeProjector Lamp
- Wattage165W
- Lamp Life2,000 Hrs.
- Ready-to-install module with bulb and housing included
- 165W UHB lamp delivers specified brightness
- 2000-hour rated life supports extended use
- Manufactured to ISO 9001 quality standards
- Genuine compatible replacement for Hitachi DT00751 projectors
Ready-to-install Hitachi DT00751 module
This 165 W lamp ships as a fully assembled bulb-and-housing unit for Hitachi projectors. It replaces a spent original lamp without extra tools or alignment steps. The unit is manufactured to ISO 9001 quality checks covering ignition, voltage and run-time.
Replaces a dimming or failed OEM lamp
Swap when brightness drops below usable levels or the projector warns of end-of-life at 2 000 hours. The jump is worth it if you need reliable output for daily presentations or classroom use. It is not for buyers who want a higher-wattage upgrade or a longer-rated module.
Simple housing swap in minutes
Open the projector lamp door, release the retaining screws and slide the old module out. Insert the new unit, secure the screws and reset the lamp timer in the menu. The only common issue is forgetting the timer reset, which leaves the warning active.
Highlights
- Ready-to-install module with bulb and housing included
- 165W UHB lamp delivers specified brightness
- 2000-hour rated life supports extended use
- Manufactured to ISO 9001 quality standards
- Genuine compatible replacement for Hitachi DT00751 projectors
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 165W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What housing does the DT00751 lamp module include for mounting?
The DT00751 arrives as a fully assembled module with a new 165W UHB bulb already seated in its housing, so it fits directly into the projector's lamp compartment without separate mounting hardware.
What is the installation step people often miss when replacing the DT00751 lamp?
After inserting the new DT00751 module, you must reset the projector's lamp-hour counter through the on-screen menu; otherwise the projector will continue counting from the old lamp's hours and may shut down prematurely.
When should the DT00751 lamp be replaced based on its rated life?
The lamp is rated for 2,000 hours of operation; plan to replace it once the projector's lamp timer approaches that figure to maintain brightness and avoid unexpected shutdowns.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



