We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Hitachi CPX605LAMP projector lamp module with 285W NSH bulb in housing

Hitachi, Ltd.

Hitachi, Ltd. CPX605LAMP Projector Lamp 285W

SKU CH-KFV4-B2SPM

A ready-to-install 285W projector lamp module with a new NSH bulb and housing for Hitachi projectors

  • TypeProjector Lamp
  • Wattage285W
  • Genuine Hitachi replacement lamp ready for immediate installation
  • 285W NSH bulb delivers correct brightness for CPX605 projectors
  • Manufactured to ISO9001 quality standards for reliable performance
  • Fully assembled module with housing enables tool-free lamp change
  • New condition ensures full rated lifespan from first use

Ready-to-install 285W replacement lamp

The Hitachi CPX605LAMP module ships as a complete bulb-and-housing assembly so technicians can swap it into a compatible projector without handling a bare burner. It uses a 285W NSH lamp built to ISO 9001 quality checks for ignition, voltage and run-time consistency. The unit is new and intended as a direct replacement for the original equipment lamp.

Suited for maintenance teams and home users

Facilities staff who need a quick, tool-free swap during scheduled downtime will value the pre-assembled housing. Buyers who require a bare bulb only, or who service projector models not listed as compatible with the CPX605LAMP, should look at other parts.

Fits into a projector service workflow

The module slides into the lamp cage of supported Hitachi projectors and connects to the existing power supply without extra cabling or firmware steps. Because the housing is included, the old cartridge is removed in one piece, freeing the technician from separate bulb alignment or reflector cleaning.

Highlights

  • Genuine Hitachi replacement lamp ready for immediate installation
  • 285W NSH bulb delivers correct brightness for CPX605 projectors
  • Manufactured to ISO9001 quality standards for reliable performance
  • Fully assembled module with housing enables tool-free lamp change
  • New condition ensures full rated lifespan from first use

Specifications

TypeProjector Lamp
Wattage285W

Questions about this item

Which Hitachi projector models accept the CPX605LAMP 285W lamp module?

The CPX605LAMP is built for Hitachi projectors that specify the 605 lamp code; check your projector's manual or lamp door label for the exact 605 designation before ordering.

Will the 285W NSH bulb run correctly in a projector that originally shipped with a lower-wattage lamp?

No — the projector's power supply and cooling are calibrated for a specific wattage, so only replace a 285W original with this 285W module.

How can I verify the lamp is performing correctly after installation?

Reset the projector's lamp-hour counter to zero, then confirm a stable, bright image with no flicker or warning messages during the first few hours of use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.