Hitachi, Ltd.
Hitachi, Ltd. CP-X938WB DT00236 150W projector lamp
A ready-to-install 150 W lamp module rated for 2,000 hours of projector use
- TypeProjector Lamp
- Wattage150W
- Lamp Life2,000 Hrs.
- Ready-to-install module saves setup time
- 150W UHP bulb delivers specified brightness
- 2,000-hour rated life supports extended use
- Genuine compatible design matches CP-X938WB requirements
- ISO 9001 manufacturing ensures consistent quality
Genuine 150W replacement lamp
This 150W UHP lamp module is built for the Hitachi CP-X938WB projector. It ships as a complete housing and bulb assembly so the unit slots in without extra steps. Rated life is 2,000 hours under normal use. The part corresponds to manufacturer reference DT00236.
Suits owners needing a direct swap
It fits users who want a ready-to-install module that matches the original 150W specification. Buyers who need a different wattage or a bare bulb without housing should look elsewhere. The lamp is produced to ISO9001 quality checks for ignition, voltage and run-time consistency.
150W UHP rating decides compatibility
The single figure that determines fit is the 150W power rating paired with the CP-X938WB model designation. If your projector calls for a different wattage or a different lamp code this module will not operate correctly. Verify the 150W requirement before ordering.
Highlights
- Ready-to-install module saves setup time
- 150W UHP bulb delivers specified brightness
- 2,000-hour rated life supports extended use
- Genuine compatible design matches CP-X938WB requirements
- ISO 9001 manufacturing ensures consistent quality
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 150W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What housing dimensions or connector type does the DT00236 lamp module use to fit the CP-X938WB projector?
The DT00236 module is a fully assembled 150W bulb and housing designed to match the CP-X938WB projector's lamp compartment and connector.
What is the correct installation sequence for the CP-X938WB lamp module, and which step is most often missed?
Power off and cool the projector, remove the lamp cover, release the securing screws, slide the DT00236 module in until the connector seats firmly, retighten screws, replace cover, then reset the lamp timer in the menu — the timer reset is the step most often missed.
When and how should the UHP 150W lamp be replaced after its rated life?
Replace the lamp once the projector indicates end of life or after approximately 2000 hours of use; install a new DT00236 module following the same installation steps and reset the lamp timer again.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



