Hitachi, Ltd.
Hitachi, Ltd. CP-X417 Genuine Compatible Projector Lamp 220W 2000 Hrs
A 220 W projector lamp module with a 2,000-hour rated life, supplied as a complete housing for direct replacement
- TypeProjector Lamp
- Wattage220W
- Lamp Life2,000 Hrs.
- 220W UHB lamp delivers bright projection for the CP-X417
- 2000-hour rated life reduces replacement frequency
- Fully assembled bulb and housing enables quick installation
- Manufactured to ISO 9001 quality standards for reliable performance
- Genuine compatible module fits Hitachi CP-X417 projectors
Ready-to-install lamp module
The CP-X417 lamp arrives as a complete 220 W bulb-and-housing assembly that fits directly into compatible Hitachi projectors. No separate bulb handling or alignment is required, so maintenance downtime stays minimal.
2 000-hour rated life
At the rated 2 000 hours the lamp reaches its specified end of life, making this module the correct choice when the projector counter shows that interval has been reached. Installing a fresh unit restores the original brightness and colour balance for another full cycle.
Stable output under continuous use
The UHB lamp is manufactured to ISO 9001 quality checks for ignition, voltage and run-time, so brightness remains consistent during extended presentations or classroom sessions. Each unit is tested for beam performance before it leaves the factory.
Highlights
- 220W UHB lamp delivers bright projection for the CP-X417
- 2000-hour rated life reduces replacement frequency
- Fully assembled bulb and housing enables quick installation
- Manufactured to ISO 9001 quality standards for reliable performance
- Genuine compatible module fits Hitachi CP-X417 projectors
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 220W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How does the 220W rating affect brightness and heat in my CP-X417 projector?
The 220W UHB bulb delivers the original light output designed for the CP-X417, so image brightness matches the factory specification; the housing is built to handle the matching thermal load.
What lamp interface does the DT00841 module use to connect inside the projector?
The module plugs directly into the CP-X417's proprietary lamp connector; no adapters or cable changes are required for installation.
Will the assembled housing fit the CP-X417 lamp compartment without modification?
Yes, the bulb comes pre-mounted in a housing shaped for the CP-X417, so it slides into the lamp compartment and secures with the existing screws.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



