We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Hitachi CP-X2515WN projector lamp module with 180W bulb in housing

Hitachi, Ltd.

Hitachi, Ltd. CP-X2515WN projector lamp 180W DT01371

SKU CH-047V-SA2KP

180W UHP replacement lamp module with housing, rated for 2,000 hours of use

  • TypeProjector Lamp
  • Wattage180W
  • Lamp Life2,000 Hrs.
  • Ready-to-install module with new Philips UHP 180W bulb
  • 2000-hour rated lamp life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Tested for beam performance ignition voltage and run-time
  • Compatible with Hitachi CP-X2515WN projector model DT01371

Hitachi CP-X2515WN replacement lamp

This 180W lamp module fits the Hitachi CP-X2515WN projector and ships as a fully assembled bulb and housing. It is intended for users whose original lamp has reached the end of its rated life and who need a direct replacement that requires no additional assembly. The unit is supplied new and ready to install.

Replaces a spent 180W UHP lamp

The module restores brightness when the existing lamp has dimmed after roughly 2000 hours of use or when the projector signals that a change is due. Swapping at that point avoids sudden failure during a presentation and keeps image quality consistent. It is not a brightness upgrade and will not extend the native lamp-life rating beyond the specified hours.

Tool-free housing swap

Installation consists of opening the projector’s lamp door, removing the old module and inserting the new one until it seats firmly. The most common issue is forgetting to reset the lamp-hour counter in the projector menu, which leaves the replacement warning active. Ensure the housing clicks into place and the door is secured before powering on.

Highlights

  • Ready-to-install module with new Philips UHP 180W bulb
  • 2000-hour rated lamp life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Tested for beam performance ignition voltage and run-time
  • Compatible with Hitachi CP-X2515WN projector model DT01371

Specifications

TypeProjector Lamp
Wattage180W
Lamp Life2,000 Hrs.

Questions about this item

What housing size does the DT01371 lamp module need inside the CP-X2515WN projector?

The DT01371 is a fully assembled 180 W bulb-and-housing unit built to the exact dimensions of the original CP-X2515WN lamp cavity, so it slides straight into the existing compartment without adapters.

Which step do installers most often skip when fitting the DT01371 lamp?

After seating the module, the projector’s lamp-hour counter must be reset through the on-screen menu; otherwise the unit will still show the old 2 000-hour limit and may shut down early.

When will the Philips UHP 180 W bulb inside the DT01371 need replacement?

The lamp is rated for 2 000 hours of typical use; once the projector’s timer reaches that figure the bulb should be swapped for a new DT01371 module to maintain brightness and colour accuracy.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.