Hitachi, Ltd.
Hitachi, Ltd. CP-X200 220W Projector Lamp DT00841 2000 Hrs
A 220 W replacement lamp module with a 2 000-hour UHB bulb pre-fitted in its housing for quick installation
- TypeProjector Lamp
- Wattage220W
- Lamp Life2,000 Hrs.
- Ready to install with bulb and housing assembled
- 220 W UHB bulb delivers rated brightness
- 2 000 hour lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-X200 projectors
Hitachi CP-X200 Replacement Lamp
The Hitachi CP-X200 lamp module (model DT00841) is a new 220W UHB replacement projector lamp supplied as a fully assembled bulb and housing for immediate installation in compatible Hitachi projectors. It is intended for users who need to restore brightness after the original lamp reaches end of life. Buyers who require a bare bulb without housing or a higher-wattage module should look elsewhere.
220 Watt UHB Lamp
The single specification that determines fit is the 220W UHB lamp type; the module is manufactured to match the original electrical and optical requirements of the CP-X200 series. Using a lamp of different wattage or bulb technology will prevent correct ignition and image performance.
2000 Hour Rated Life
Rated lamp life is 2000 hours under normal operating conditions; the 220W power draw is consistent with the projector's original thermal design. The housing allows the existing cooling system to manage heat and fan noise at the levels the projector was engineered for.
Highlights
- Ready to install with bulb and housing assembled
- 220 W UHB bulb delivers rated brightness
- 2 000 hour lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-X200 projectors
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 220W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What does the 220W rating mean for brightness and heat in my Hitachi CP-X200 projector?
The 220W Ushio UHB bulb delivers the original light output designed for the CP-X200. Expect the same brightness and thermal load as the factory lamp, so your projector's existing cooling handles it normally.
Does the lamp use a standard connector or a proprietary interface for the CP-X200?
It plugs directly into the Hitachi CP-X200 lamp socket using the original connector. No adapters or wiring changes are needed; the module seats exactly like the factory unit.
What physical space and mounting points does the DT00841 housing require?
The fully assembled housing matches the CP-X200 lamp cage dimensions and screw locations. It slides into the projector's lamp compartment and secures with the existing captive screws.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



