Hitachi, Ltd.
Hitachi, Ltd. CP-X1 Projector Lamp DT00781 160W 2000 Hrs
A 160 W replacement lamp module with a 2,000-hour rated life, supplied as a complete housing for straightforward installation
- TypeProjector Lamp
- Wattage160W
- Lamp Life2,000 Hrs.
- Ready to install — new 160W lamp module with housing included
- 2000 hours rated life for extended projector use
- Philips UHB bulb delivers original-equipment brightness
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-X1 projectors using DT00781
Ready-to-install replacement lamp
This replacement lamp module fits the Hitachi CP-X1 projector and arrives as a fully assembled bulb and housing. It uses a genuine Philips UHB 160W bulb so no separate lamp assembly is required. The unit is supplied new and ready for immediate installation.
Consistent output over 2000 hours
The lamp is rated for 2000 hours of operation under normal use. Output remains stable throughout the rated life rather than dropping sharply after a short initial period. ISO 9001 manufacturing checks verify ignition, voltage and run-time consistency for each unit.
Standard 160W thermal profile
At 160 watts the lamp follows the thermal and acoustic profile designed for the CP-X1 chassis. Fan noise and case temperature stay within the projector's original specifications. Power draw matches the factory lamp so no electrical modifications are needed.
Highlights
- Ready to install — new 160W lamp module with housing included
- 2000 hours rated life for extended projector use
- Philips UHB bulb delivers original-equipment brightness
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-X1 projectors using DT00781
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 160W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the 160 W lamp generate noticeable heat or fan noise during all-day use?
The lamp draws 160 W, so the projector’s cooling fan will run while it is on; heat and noise levels depend on the projector model rather than the lamp itself.
What must I already own for this DT00781 module to work?
You need a compatible Hitachi projector that accepts the CP-X1 lamp; the module includes the bulb and housing ready for direct installation.
Will this 2 000-hour lamp perform reliably in an older Hitachi projector I have kept?
Yes — the lamp is built to ISO 9001 standards with a genuine Philips UHB bulb, matching the original specifications for consistent ignition and brightness in legacy units.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



