Hitachi, Ltd.
Hitachi, Ltd. CP-WX3042WN Projector Lamp 225W 5000-6000 Hrs
A replacement lamp module with a 225 W UHP bulb rated for 5,000 to 6,000 hours, supplied in a housing for direct fitting
- TypeUHP
- Wattage225W
- Lamp Life5,000 (Normal) - 6,000 (Economy) Hrs.
- Ready to install with pre-assembled bulb and housing
- Bright 225W UHP output for clear projection
- Up to 6000 hours lamp life in economy mode
- Built to ISO 9001 quality standards
- Genuine Philips UHP bulb inside
Direct Replacement Lamp Module
The Hitachi CP-WX3042WN lamp module arrives as a complete 225W UHP bulb and housing assembly. It is designed for immediate installation in compatible Hitachi projectors without additional tools or alignment steps. The unit carries the manufacturer part reference DT01481 for exact model matching.
Restores Original Brightness
This module replaces a dimmed or expired lamp to return the projector to its factory light output. The upgrade is worthwhile when the existing lamp has reached its rated hours or shows noticeable colour shift. Economy mode extends the service interval to 6000 hours while normal mode provides 5000 hours of operation.
Stable Output Over Extended Use
The lamp maintains consistent beam performance across the full rated life thanks to ISO9001 production controls and per-unit testing of ignition voltage and run-time. Each unit is verified for reliable start-up and steady output during long presentations or continuous playback sessions.
Highlights
- Ready to install with pre-assembled bulb and housing
- Bright 225W UHP output for clear projection
- Up to 6000 hours lamp life in economy mode
- Built to ISO 9001 quality standards
- Genuine Philips UHP bulb inside
Specifications
| Brand | HITACHI |
|---|---|
| Type | UHP |
| Wattage | 225W |
| Lamp Life | 5,000 (Normal) - 6,000 (Economy) Hrs. |
Questions about this item
Which Hitachi projector models accept the DT01481 lamp module?
The DT01481 module is built for the CP-WX3042WN projector and fits the same lamp compartment used by that model.
What is the correct sequence for installing the DT01481 lamp, and which step is most often missed?
Power off the projector, let it cool, remove the lamp cover, release the retaining screws, slide the old module out, insert the new DT01481 unit until it seats firmly, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most often forgotten.
When should the DT01481 lamp be replaced, and what indicates end of life?
Replace the lamp after 5,000 hours in normal mode or 6,000 hours in economy mode; the projector will show a replacement warning and brightness will drop noticeably when the limit is reached.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Tripp Lite U324-003-BK USB 3.0 cable USB-A to USB-A 3 ft
- USB
- Black


