Hitachi, Ltd.
Hitachi, Ltd. CP-S318W Projector Lamp 150W 2000 Hrs
A 150 W CP-S318W lamp module with Philips UHB bulb and housing, rated for 2,000 hours
- TypeProjector Lamp
- Wattage150W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled housing
- 150W Philips UHB bulb delivers bright projection
- 2000 hours of lamp life per module
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-S318W projector model
Replacement Lamp for CP-S318W Projectors
This 150W projector lamp module is built for owners of Hitachi CP-S318W units who need a direct replacement. The assembly arrives with the Philips UHB bulb already seated in its housing, so installation is a simple swap without separate handling of the bare lamp. It suits anyone restoring original brightness after the factory lamp reaches end of life.
Thermal and Power Profile
The lamp draws 150W during operation, matching the projector's original power specification. Rated life is 2,000 hours under normal use, after which output will gradually decline. Heat and fan noise remain consistent with the projector's stock behaviour because the module replicates the OEM thermal footprint. No extra cooling or power-supply changes are required.
Build Quality and Daily Use
Each unit is manufactured to ISO9001 standards and tested for beam performance, ignition voltage, connections and run-time before shipping. The pre-assembled housing means no alignment of the bulb is needed — just remove the old module and insert the new one. Compatibility is limited to the CP-S318W (model DT00461); it will not fit other Hitachi or third-party projectors.
Highlights
- Ready to install with pre-assembled housing
- 150W Philips UHB bulb delivers bright projection
- 2000 hours of lamp life per module
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-S318W projector model
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 150W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How do I install the DT00461 lamp module, and what step is often missed?
The module arrives fully assembled with bulb and housing; power off the projector, let it cool completely, remove the old lamp, insert the new module until it seats firmly, then reset the lamp timer in the menu — skipping the timer reset is the step most users forget.
What maintenance or replacement will the CP-S318W lamp need later?
The lamp is rated for 2000 hours of use; after that the bulb reaches end of life and the entire module must be replaced — no separate filter or bulb-only change is required.
What limit appears first during sustained operation of this 150W UHB lamp?
The 2000-hour rated lamp life is the first hard limit; brightness will gradually decline as that point is approached, and the projector will eventually require a new lamp module.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



