Hitachi, Ltd.
Hitachi, Ltd. CP-S317W Projector Lamp 150W 2000 Hrs
A 150 watt replacement lamp module with 2,000 hour life for Hitachi projectors
- TypeProjector Lamp
- Wattage150W
- Lamp Life2,000 Hrs.
- Ready-to-install module with housing included
- 150 W UHB bulb delivers bright projection
- 2000-hour rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-S317W projector model
Direct Replacement Lamp
The Hitachi CP-S317W lamp module ships as a fully assembled bulb and housing, model DT00461, ready for tool-free installation in compatible Hitachi projectors. It uses a 150W UHB bulb rated for 2000 hours of operation. This new OEM replacement restores original brightness without requiring projector recalibration.
Assembled Housing Simplifies Maintenance
The pre-fitted housing eliminates the handling of a bare bulb, reducing the risk of contamination or misalignment during a changeover. Each unit is tested for beam performance, ignition voltage, connections and run-time under ISO 9001 controls. The plug-and-play design means downtime is limited to the projector cool-down and swap cycle.
Restores Factory Output After Dim or Failed Lamps
When the existing lamp reaches its rated life or shows colour shift, this module returns the projector to its specified luminance and uniformity. The jump is worthwhile once image brightness drops below usable levels for presentations or classroom use. It does not address projectors that require higher-wattage modules or different form factors.
Highlights
- Ready-to-install module with housing included
- 150 W UHB bulb delivers bright projection
- 2000-hour rated lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-S317W projector model
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 150W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the 150W lamp module connect directly to the projector's existing power connector?
The DT00461 module is a complete bulb-and-housing assembly that plugs into the same connector used by the original lamp.
Will the assembled housing fit the CP-S317W chassis without modification?
The unit is built to the original DT00461 form factor, so it slides into the CP-S317W lamp compartment and locks with the existing screw points.
What step is often missed when installing this lamp module?
After fitting the module, the lamp-hour counter in the projector menu must be reset to zero so the 2,000-hour rating tracks correctly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



