Hitachi, Ltd.
Hitachi, Ltd. CP-S310 Genuine Compatible Replacement Projector Lamp 160W 2000 Hrs
A new 160 W replacement lamp module with a 2,000-hour rated life for the CP-S310 projector
- TypeProjector Lamp
- Wattage160W
- Lamp Life2,000 Hrs.
- Ready-to-install module with 160W UHB bulb and housing
- 2,000-hour lamp life for extended projector use
- Manufactured to ISO 9001 quality standards
- Genuine compatible replacement for Hitachi CP-S310 projectors
- Supplied new and fully assembled for immediate use
Ready-to-install projector lamp module
The Hitachi CP-S310 replacement lamp ships as a fully assembled 160 W UHB bulb inside its housing. It matches the original DT00331 part number and is ready for immediate installation in compatible Hitachi projectors. No additional assembly or alignment is required before use.
Rated output and service life
The lamp draws 160 W and is rated for 2 000 hours of operation under normal conditions. It uses a UHB light source manufactured to ISO 9001 quality standards with checks for ignition, voltage stability and run-time consistency. Typical projector cooling systems handle the thermal load without special measures.
Direct-fit housing for simple swaps
The integrated housing mirrors the factory mechanical interface so the module seats securely in the projector's lamp bay. Connectors align with the existing power and signal contacts, allowing a straight-forward swap without tools or adapter cables. Buyers needing a higher-wattage alternative or a different form factor should look elsewhere.
Highlights
- Ready-to-install module with 160W UHB bulb and housing
- 2,000-hour lamp life for extended projector use
- Manufactured to ISO 9001 quality standards
- Genuine compatible replacement for Hitachi CP-S310 projectors
- Supplied new and fully assembled for immediate use
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 160W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How do I install the CP-S310 lamp module in my projector?
The CP-S310 module arrives fully assembled with the 160W UHB bulb inside its housing, so you simply open the projector lamp door, remove the old unit, slide the new module in until it seats, and close the door.
When will the CP-S310 lamp need replacement?
The lamp is rated for 2,000 hours of use; after that the brightness drops and the projector will prompt you to install a new module.
What limits the CP-S310 lamp during long sessions?
The 160W UHB bulb generates heat that the projector fan must manage; if airflow is blocked the lamp will reach its thermal limit and shut down.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



