Hitachi, Ltd.
Hitachi, Ltd. CP-S235W projector lamp 160W 2000 hrs
Genuine replacement lamp module with 160W UHB bulb and housing delivers 2,000 hours of projector runtime
- TypeProjector Lamp
- Wattage160W
- Lamp Life2,000 Hrs.
- 160 W UHB lamp delivers bright projection
- 2000-hour rated life supports extended use
- Genuine compatible module fits Hitachi CP-S235W
- ISO 9001 manufacturing ensures consistent quality
- Pre-assembled bulb and housing enables quick installation
What this lamp replaces
This Hitachi CP-S235W replacement lamp module fits the specified projector models. It arrives as a complete unit with the 160 W UHB bulb already seated in its housing, so installation requires no separate bulb handling. The part corresponds to manufacturer reference DT00621 and is supplied new. It suits owners needing a direct swap for a dim or expired original lamp.
Heat output and power draw
The lamp operates at a rated 160 W, which determines both its light output and the thermal load the projector must dissipate. Normal running temperature and fan noise therefore follow the projector's original design envelope. No additional cooling provision is required beyond what the host unit already provides for this lamp type.
Rated service life
Expected lamp life is 2 000 hours under typical operating conditions. This figure reflects continuous use at the specified wattage rather than a short-term peak. Actual endurance will vary with power-cycle frequency, ambient temperature and the projector's own power-management settings.
Highlights
- 160 W UHB lamp delivers bright projection
- 2000-hour rated life supports extended use
- Genuine compatible module fits Hitachi CP-S235W
- ISO 9001 manufacturing ensures consistent quality
- Pre-assembled bulb and housing enables quick installation
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 160W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How do I install the CP-S235W lamp module, and which step do people usually get wrong?
The module arrives with the 160 W UHB bulb already seated in its housing, so you only need to open the projector's lamp door, remove the old unit, and slide this one in until the connector seats firmly; the step most people miss is forgetting to reset the lamp-hour counter in the menu after fitting it.
What maintenance or replacement will this lamp need later?
The 160 W UHB bulb is rated for 2,000 hours of use; once that limit is reached you simply purchase another CP-S235W module and swap it the same way — no separate filter or coolant service is required.
What limit appears first during long sessions with this lamp?
The 2,000-hour rated life is the primary limit; after those hours the 160 W UHB bulb's output drops off and the projector will prompt for a replacement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



