Hitachi, Ltd.
Hitachi, Ltd. CP-RX80 OEM Philips Projector Lamp 210W 3000/6000 Hrs
Replacement projector lamp module with a 210 W Philips UHP bulb delivering 3,000 to 6,000 hours of life
- TypeProjector Lamp
- Wattage210W
- Lamp Life3,000 (Normal) - 6,000 (Economy) Hrs.
- Ready to install with pre-assembled bulb and housing
- 210W Philips UHP bulb powers bright projection
- Up to 6000 hours life in economy mode
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-RX80 projector models
Replacement Lamp for CP-RX80 Projectors
This 210W UHP lamp module ships fully assembled with bulb and housing for direct installation in Hitachi CP-RX80 projectors. It arrives new and is manufactured to ISO9001 quality standards using genuine Philips components. The unit is ready to install without additional tools or alignment steps.
Suited for Owners Needing a Direct Swap
This module suits users who want an OEM-specification replacement that matches the original 210W rating and 3000 to 6000 hour life range. Buyers who require a different wattage, a bare bulb without housing, or compatibility with other projector models should look at alternative parts.
Steady Output Across Rated Hours
Under sustained operation the lamp maintains consistent brightness for up to 3000 hours in normal mode or 6000 hours in economy mode. The ISO9001 production checks verify ignition stability, voltage regulation and beam performance throughout the rated lifespan rather than only at initial start-up.
Highlights
- Ready to install with pre-assembled bulb and housing
- 210W Philips UHP bulb powers bright projection
- Up to 6000 hours life in economy mode
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-RX80 projector models
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 3,000 (Normal) - 6,000 (Economy) Hrs. |
Questions about this item
Does this lamp fit my Hitachi CP-RX80 projector without extra parts?
Yes, the module ships as a fully assembled 210 W Philips UHP bulb inside its housing, matching the DT01022 specification for direct installation.
Will the lamp still reach full brightness if I keep using the projector's original power supply and cooling system?
The lamp is built to the same 210 W rating and 3 000 / 6 000 hour life figures as the original, so the existing power supply and cooling handle it normally.
How can I confirm the lamp is operating correctly after I install it?
Reset the projector's lamp-hour counter, then verify the on-screen timer starts from zero and the image reaches normal brightness without flicker.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



