Hitachi, Ltd.
Hitachi, Ltd. CP-RX70 Projector Lamp 160W 2000 Hrs
A 160 watt replacement lamp module with a 2,000 hour rated life, supplied as a complete housing for quick installation in compatible Hitachi projectors
- TypeProjector Lamp
- Wattage160W
- Lamp Life2,000 Hrs.
- Ready-to-install module saves setup time
- 160 W UHB bulb matches original brightness
- 2,000-hour rated life reduces replacement frequency
- Manufactured to ISO 9001 quality standards
- Fits Hitachi CP-RX70 projectors (model DT00781)
Hitachi CP-RX70 projector lamp module
The Hitachi CP-RX70 lamp module is a new 160 W UHB replacement assembly that includes a Philips bulb pre-mounted in its housing. It is designed for owners of compatible Hitachi projectors who need a direct, ready-to-fit light source without separate bulb handling.
Replaces the original DT00781 lamp after 2000
When the factory-fitted lamp reaches its rated 2 000-hour service life, brightness drops and the projector signals a replacement. Swapping in this module restores original output and resets the timer, so the projector returns to its intended image quality for another full cycle.
Fits the CP-RX70 chassis with no extra parts
The pre-assembled housing aligns with the projector's lamp cage and connector, allowing tool-free insertion. No separate ballast, filter or cable is required, and the module meets ISO 9001 manufacturing checks for ignition, voltage and run-time stability.
Highlights
- Ready-to-install module saves setup time
- 160 W UHB bulb matches original brightness
- 2,000-hour rated life reduces replacement frequency
- Manufactured to ISO 9001 quality standards
- Fits Hitachi CP-RX70 projectors (model DT00781)
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 160W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Will the DT00781 lamp module fit directly into my CP-RX70 projector without extra brackets?
The DT00781 is a fully assembled bulb-and-housing module built for the CP-RX70, so it seats in the projector's lamp bay without additional brackets or adapters.
What is the correct sequence for installing the DT00781 lamp, and which step do users most often miss?
Power off and unplug the projector, let it cool, remove the lamp cover, slide out the old module, insert the new DT00781 until it clicks, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most often missed.
How long should the 160 W UHB bulb last before I need another DT00781 module?
The lamp is rated for 2,000 hours of typical use; after that the bulb will dim and you will need a new DT00781 module to restore full brightness.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



