Hitachi, Ltd.
Hitachi, Ltd. CP-HX995 DT00701 Projector Lamp 165W 2000 Hrs
Ready-to-install 165 W replacement lamp module rated for 2,000 hours of projector use
- TypeProjector Lamp
- Wattage165W
- Lamp Life2,000 Hrs.
- Ready-to-install module with genuine Philips UHB 165W bulb
- 2,000-hour lamp life supports extended projection time
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-HX995 DT00701 projectors
- New OEM replacement lamp in complete housing assembly
Direct-fit replacement for CP-HX995
This 165 W lamp module fits the Hitachi CP-HX995 projector and ships as a complete bulb-and-housing assembly. Installation requires no extra tools or alignment steps. The unit is supplied new and ready to use.
Assembled housing with ISO 9001 build
The module arrives fully assembled, so the installer simply removes the old cartridge and slots this one in. Manufacturing follows ISO 9001 quality checks covering ignition, voltage, beam performance and run-time. A genuine Philips UHB bulb sits inside the housing.
2 000-hour rated life at 165 W
Rated output is 165 W with a 2 000-hour service life under standard operating conditions. Buyers who need a longer interval between changes or a different wattage will need another lamp model.
Highlights
- Ready-to-install module with genuine Philips UHB 165W bulb
- 2,000-hour lamp life supports extended projection time
- Manufactured to ISO 9001 quality standards
- Compatible with Hitachi CP-HX995 DT00701 projectors
- New OEM replacement lamp in complete housing assembly
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 165W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What wattage does the 165W UHB lamp draw, and what practical limit does that set?
The lamp draws 165 W, which is the exact power budget the projector’s ballast and cooling are designed for; exceeding it would trip the thermal protection or shorten the 2,000-hour rated life.
Which housing dimensions and connector layout must match the Hitachi CP-HX995 DT00701 module?
The replacement ships as a fully assembled bulb-and-housing unit built to the CP-HX995 DT00701 form factor, so the mounting tabs, lens alignment and power plug seat directly without adapters.
What is the correct installation sequence for the new lamp module, and which step is most often missed?
Power off and unplug the projector, allow the old lamp to cool, remove the lamp cover, swap the complete module, replace the cover, then reset the lamp-hour counter in the menu — the counter reset is the step users forget.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



