Hitachi, Ltd.
Hitachi, Ltd. CP-AW251NM Projector Lamp 210W 5000 Hrs
A new 210 W replacement lamp module with housing, rated for 5,000 hours of use
- TypeProjector Lamp
- Wattage210W
- Lamp Life5,000 Hrs.
- Ready to install — fully assembled 210W bulb and housing
- 5000-hour lamp life for extended projector use
- Philips UHP 210W bulb delivers reliable brightness
- Manufactured to ISO9001 quality standards for consistent performance
- Compatible with Hitachi CP-AW251NM projector model DT01181
Direct Replacement for Hitachi Projectors
The CP-AW251NM module fits Hitachi projectors requiring the DT01181 lamp code. It ships as a complete 210W bulb-and-housing assembly so installation takes seconds. The lamp is new and built to ISO 9001 quality checks for beam performance, ignition, voltage and run-time. Buyers who need a different connector or a higher-wattage module cannot use this unit.
Upgrades from Dim or Expired OEM Lamps
When the original lamp reaches its 5,000-hour rating or brightness drops below usable levels, this module restores factory luminance. The jump is worth it when image quality has faded or the projector warns of end-of-life. Projectors that accept only a different wattage or a non-UHP bulb type will not accept this replacement.
5,000-Hour UHP Light Source
The 210W Philips UHP bulb delivers up to 5,000 hours of typical operation before replacement is needed. That headroom covers daily classroom or meeting-room use for multiple years. Environments that run the projector continuously beyond the rated duty cycle will exhaust the lamp sooner.
Highlights
- Ready to install — fully assembled 210W bulb and housing
- 5000-hour lamp life for extended projector use
- Philips UHP 210W bulb delivers reliable brightness
- Manufactured to ISO9001 quality standards for consistent performance
- Compatible with Hitachi CP-AW251NM projector model DT01181
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 5,000 Hrs. |
Questions about this item
Does the CP-AW251NM lamp module include the housing so it fits directly into the projector?
Yes, the module is supplied as a fully assembled 210W bulb inside its housing, matching the original DT01181 form factor for direct installation.
What is the correct installation sequence for the CP-AW251NM lamp, and which step is most often missed?
Power off and unplug the projector, allow it to cool completely, remove the lamp cover, swap the module, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most frequently forgotten.
After roughly 5000 hours of use, what part of the CP-AW251NM will need replacement?
The entire lamp module (bulb and housing) should be replaced once the 5000-hour rated life is reached, as the UHP bulb cannot be serviced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



