Hitachi, Ltd.
Hitachi, Ltd. CP-A200 DT00893 Projector Lamp 200W
A genuine 200W replacement lamp module with housing delivers 2,000 to 3,000 hours of projection life
- TypeProjector Lamp
- Wattage200W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Genuine compatible replacement lamp with new 200W UHB bulb
- Ready-to-install module includes bulb and housing for easy setup
- Lamp life of 2000 hours normal or 3000 hours economy mode
- Manufactured to ISO 9001 quality standards with strict performance checks
- Compatible with Hitachi CP-A200 projector model DT00893
Genuine Replacement Lamp Module
The Hitachi CP-A200 DT00893 is a new 200W projector lamp module supplied as a fully assembled bulb and housing. It is designed for direct installation in compatible Hitachi projectors without additional assembly.
200W UHB Lamp Specification
The lamp uses a 200W UHB bulb, which is the single specification that determines compatibility with the projector's optical and electrical system. Matching this wattage and lamp type is essential for correct operation.
Rated Life and Operating Modes
In normal mode the lamp is rated for 2000 hours of use, while economy mode extends the rating to 3000 hours. This provides a clear indication of the replacement interval for typical projection workloads.
Highlights
- Genuine compatible replacement lamp with new 200W UHB bulb
- Ready-to-install module includes bulb and housing for easy setup
- Lamp life of 2000 hours normal or 3000 hours economy mode
- Manufactured to ISO 9001 quality standards with strict performance checks
- Compatible with Hitachi CP-A200 projector model DT00893
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 200W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
How bright will the 200W UHB lamp actually look in my Hitachi CP-A200 projector?
The 200W UHB lamp restores the projector's original brightness specification, delivering the same lumen output as the factory-installed module for clear images in typical meeting-room lighting.
Does the DT00893 lamp module use a standard projector-lamp connector, and will it hit any firmware lock?
The module uses the exact connector and pin-out designed for the CP-A200 series, so it seats without adapters and the projector recognises it immediately with no firmware restriction.
What clearance and mounting points does the assembled housing need inside the CP-A200?
The pre-assembled housing matches the original lamp cage dimensions and screw-hole pattern, sliding into the CP-A200 lamp compartment and securing with the two captive screws already on the projector.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



