We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Hitachi CP-A100 projector lamp module with 220W bulb in housing

Hitachi, Ltd.

Hitachi, Ltd. CP-A100 / CPA100LAMP 220W Projector Lamp

SKU CH-F4YG-AD92C

A ready-to-install 220W replacement lamp module rated for 2,000 hours of projector use

  • TypeProjector Lamp
  • Wattage220W
  • Lamp Life2,000 Hrs.
  • Ready-to-install module saves setup time
  • Philips UHB 220W bulb delivers specified brightness
  • 2,000-hour rated life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Compatible with Hitachi CP-A100 projector model

Direct replacement for Hitachi CP-A100 projectors

This 220W lamp module fits the Hitachi CP-A100 and CPA100LAMP models using part number DT00891. It arrives as a complete bulb-and-housing assembly so the projector is back in service after a single swap. The unit is new and built to the original 220W specification.

Pre-assembled housing with Philips UHB bulb

The module ships fully assembled, removing the need to handle a bare bulb or align reflectors during installation. A genuine Philips UHB 220W bulb provides the light source, and each unit passes checks for beam performance, ignition voltage and run-time before it leaves the factory. ISO 9001 manufacturing standards apply to every version stocked.

Ready to install with no extra parts required

Because the bulb is already seated in its housing, there are no separate components to fit, no cables to route and no software to configure. The projector recognises the lamp immediately and the 2,000-hour rated life begins at first ignition. Buyers who need a higher-wattage module or a different connector pattern will need a different part.

Highlights

  • Ready-to-install module saves setup time
  • Philips UHB 220W bulb delivers specified brightness
  • 2,000-hour rated life supports extended use
  • Manufactured to ISO 9001 quality standards
  • Compatible with Hitachi CP-A100 projector model

Specifications

TypeProjector Lamp
Wattage220W
Lamp Life2,000 Hrs.

Questions about this item

What wattage does the 220W UHB lamp draw and how does that limit brightness?

The lamp is rated at 220 watts and is designed to deliver the projector’s specified light output for its rated life; it does not support higher-wattage operation.

What housing dimensions must the CP-A100 module match to fit the projector?

The module uses the exact DT00891 housing form factor so it seats in the same lamp compartment without modification.

How is the lamp installed and which step do users often miss?

Power off and cool the projector, open the lamp cover, remove the old module, insert the new DT00891 assembly until it clicks, close the cover, then reset the lamp timer in the menu.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.