Hitachi, Ltd.
Hitachi, Ltd. CP-300WN Projector Lamp 225W DT01491
Replacement lamp module with 225 W UHP bulb and housing rated for 5,000 to 6,000 hours
- TypeUHP
- Wattage225W
- Lamp Life5,000 (Normal) - 6,000 (Economy) Hrs.
- Ready-to-install module saves setup time
- Philips UHP 225W bulb delivers reliable brightness
- 5000 normal or 6000 economy hours extends replacement interval
- ISO9001 manufacturing ensures consistent quality
- OEM-spec housing guarantees exact projector fit
Direct-fit replacement for CP-300WN projectors
This module is built for owners of Hitachi CP-300WN projectors who need a factory-specification light source. It ships as a complete assembly with a new Philips UHP 225W bulb already mounted in the housing. The part matches the manufacturer reference DT01491 and is supplied new.
Tool-free swap in minutes
Installation requires only opening the projector lamp door, releasing the retaining screw and sliding the old module out before inserting the new one. No alignment, wiring or firmware steps are involved. The most common issue is forgetting to reset the internal hour counter after fitting, which leaves the replacement warning active.
225W UHP bulb rated 5000 normal / 6000 economy hours
The single figure that confirms fit is the 225W UHP rating matched to the CP-300WN chassis. If your projector specifies a different wattage or lamp code this module will not strike correctly. Buyers who need a higher-lumen lamp or a different connector type cannot use this part.
Highlights
- Ready-to-install module saves setup time
- Philips UHP 225W bulb delivers reliable brightness
- 5000 normal or 6000 economy hours extends replacement interval
- ISO9001 manufacturing ensures consistent quality
- OEM-spec housing guarantees exact projector fit
Specifications
| Brand | HITACHI |
|---|---|
| Type | UHP |
| Wattage | 225W |
| Lamp Life | 5,000 (Normal) - 6,000 (Economy) Hrs. |
Questions about this item
How can I verify the CP-300WN lamp is operating correctly after installation?
Check the projector menu for lamp hours; it should reset near zero and the image should reach full brightness with the 225W UHP bulb running normally.
What comes in the box and what must I buy separately for the DT01491 module?
The module includes a fully assembled Philips 225W UHP bulb inside its housing, ready to install; no extra parts are required.
Which version of the CP-300WN lamp should I choose among the OEM and compatible options?
All versions use genuine OEM parts built to ISO9001 standards; pick the genuine Philips OEM for original-spec performance or the compatible version for lower cost.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



