We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black SATA power cable with Micro USB and USB A connectors

HETAI Digital Technology Co.,Ltd

HETAI Digital Technology Co.,Ltd SATA Power Cable for HP EliteDesk 600 800 400 G1 G2 SFF 710825-002/710825-001

SKU CH-197B-EER36

SATA power cable for HP EliteDesk 600, 800 and 400 G1 G2 SFF models using part numbers 710825-001 or 710825-002

  • Connector TypeMicro USB to USB A
  • Powers HP EliteDesk SFF systems via SATA
  • Compatible with 600 800 400 G1 G2 models
  • Replaces HP part numbers 710825-002 and 710825-001
  • Tested 100 percent before shipment for reliability
  • New condition cable ready for immediate installation

SATA Power Cable for HP EliteDesk SFF

This cable delivers SATA power inside HP EliteDesk 600, 800 and 400 G1 G2 small-form-factor desktops. It matches part numbers 710825-002 and 710825-001, with the exact variant shipped at random unless a specific request is noted. The Micro USB to USB A connector layout is tailored to the proprietary power routing in these chassis. Builders working on other platforms or needing a standard SATA power lead cannot use this cable.

Thermals noise and power draw

The cable carries only the SATA power lines required by the installed drive or adapter, adding no active components that generate heat or noise. Power draw is determined entirely by the connected device and the desktop's own supply. Because the cable is passive, it introduces no additional thermal load or audible signature during normal operation.

Bundled accessories and software

No accessories, adapters or software are included with the cable. The sole item is the SATA power lead itself, tested to 100 percent before shipment. Compatibility is limited to the listed EliteDesk models; no driver installation or configuration utility is required or provided.

Highlights

  • Powers HP EliteDesk SFF systems via SATA
  • Compatible with 600 800 400 G1 G2 models
  • Replaces HP part numbers 710825-002 and 710825-001
  • Tested 100 percent before shipment for reliability
  • New condition cable ready for immediate installation

Specifications

Connector TypeMicro USB to USB A

Questions about this item

How do I route the Micro-USB-to-USB-A cable inside an EliteDesk SFF so the SATA power connector reaches the drive without strain?

Thread the cable along the chassis rail toward the drive bay, keep the Micro USB plug oriented toward the motherboard header, and secure the USB-A end with the existing tie-down point so the SATA power lead sits flat against the drive.

What wear should I watch for on the Micro USB and USB-A connectors after repeated drive swaps?

Inspect the Micro USB port for bent pins and the USB-A shell for spread contacts; replace the cable if either connector feels loose or shows visible metal fatigue.

At what point does voltage drop across the cable become noticeable when the drive runs sustained writes?

The thin-gauge conductors will show measurable drop once the drive draws continuous current near its rated spin-up level, so limit cable length to the factory routing path.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.