Hayward Flow Control
Hayward Flow Control TBH1100ASTV0Z00 Ball Valve 1 in
Manual two-way ball valve with PVC body and full-port Z-ball handles corrosive chemicals and water at up to 250 psi
- Manual two-way flow control for corrosive media
- PVC body and ball resist chemical attack up to 250 psi
- Full-port Z-ball design maintains unrestricted flow path
- Three-piece true-union construction enables inline maintenance
- Locking tee handle prevents accidental position changes
Manual two-way flow control
The Hayward Flow Control TBH1100ASTV0Z00 is a manual two-way ball valve built for systems handling corrosive chemicals and water. Its three-piece PVC body and full-port PVC ball provide straight-through flow with minimal restriction. The locking tee handle secures the valve in the open or closed position during operation. This valve suits plant engineers and maintenance teams who need reliable shut-off in chemical processing lines.
Thermals noise and power draw
As a manually actuated valve, the unit has no motor, pump or electrical components that generate heat or audible noise during normal use. It does not draw power and therefore adds no thermal load to the surrounding equipment. Pressure containment is rated to 250 psi for the intended media. The PVC construction resists corrosion from the specified fluids without degrading.
True union ends and locking handle
True union connections allow the centre section to be removed for seat replacement or cleaning without cutting pipe work. The Z-ball design supports full-port flow while the locking tee handle prevents accidental actuation in vibration-prone environments. No software, sensors or electronic accessories are bundled with this mechanical valve.
Highlights
- Manual two-way flow control for corrosive media
- PVC body and ball resist chemical attack up to 250 psi
- Full-port Z-ball design maintains unrestricted flow path
- Three-piece true-union construction enables inline maintenance
- Locking tee handle prevents accidental position changes
Specifications
| Brand | HAYWARD FLOW CONTROL |
|---|
Questions about this item
How do I install the 1 in true-union ball valve and which step is often missed?
Cut the pipe square, deburr the ends, solvent-weld the union nuts onto the pipe first, then thread the valve body between them; the step most often missed is tightening the union nuts before the cement fully cures, which can pull the joints out of alignment.
What maintenance will the PVC ball and PTFE seats need later?
Cycle the valve monthly to prevent the ball from seizing; if the handle becomes stiff or leakage appears at the stem, replace the PTFE seat and O-ring kit rather than the whole valve.
At what pressure limit does the 250 psi rating become the limiting factor during sustained use?
The 250 psi maximum operating pressure is the first limit reached; continuous service above that pressure will deform the PVC body and cause the Z-ball to bypass the seats.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
