Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00937614BTC
In stock
Hayward Flow Control
Hayward Flow Control BFA3015TES bulkhead tank fitting 1-1/2 in PP/EPDM FPT
Polypropylene bulkhead fitting with EPDM gasket for 1-1/2 inch female threaded connections, rated to 150 psi and 180 degrees F
- TypePipes, Valves & Fittings
- Polypropylene construction resists chemical corrosion
- EPDM gasket seals reliably across 40 to 180 °F
- 150 psi rating handles demanding tank installations
- Female threaded connections simplify pipe assembly
- Hayward Flow Control engineering ensures consistent quality
Tank fitting for curved or flat walls
The Hayward Flow Control BFA3015TES is a bulkhead tank fitting built for 1-1/2 inch female pipe thread connections on both sides. Polypropylene construction with an EPDM gasket suits water and chemical tanks that have curved or flat walls. It is intended for installers who need a straight-through bulkhead penetration without bolt-hole flanges.
Polypropylene body and EPDM seal
The polypropylene body resists corrosion from many acids, bases and salts, while the EPDM gasket provides a reliable seal across the stated temperature range. No additional gaskets, lubricants or mounting hardware are included, so the installer must supply any thread sealant or backing nuts required by the specific tank wall thickness.
Pressure and temperature limits
The fitting is rated for a maximum operating pressure of 150 psi and a maximum operating temperature of 180 degrees F, with a minimum of 40 degrees F. These limits define the safe envelope for continuous service; exceeding either value can cause the polypropylene to creep or the EPDM to degrade, leading to leaks or fitting failure.
Highlights
- Polypropylene construction resists chemical corrosion
- EPDM gasket seals reliably across 40 to 180 °F
- 150 psi rating handles demanding tank installations
- Female threaded connections simplify pipe assembly
- Hayward Flow Control engineering ensures consistent quality
Specifications
| Brand | HAYWARD FLOW CONTROL |
|---|---|
| Type | Pipes, Valves & Fittings |
Questions about this item
Will the EPDM gasket on this bulkhead fitting need periodic replacement?
The EPDM gasket seals the 1-1/2 inch connection and is rated for 40 to 180 degrees F; inspect it during routine tank maintenance and replace if it shows cracking or hardening.
What pressure limit governs continuous service for the 1-1/2 inch polypropylene body?
Maximum operating pressure is 150 psi, so sustained use must stay at or below that value to avoid stress on the threaded female ports.
How much heat does the fitting add when water runs at 150 psi all day?
The polypropylene body and EPDM gasket are rated to 180 degrees F; the fitting itself generates no heat, but fluid temperature must remain within that range.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
