Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00937559BTC
In stock
Hayward Flow Control
Hayward Flow Control BFA1015SFS bulkhead tank fitting 1-1/2 inch PVC FKM socket
Connects a 1-1/2 inch PVC pipe through a tank wall using a socket connection with FKM gasket, rated for 150 psi and temperatures from 40 to 140 degrees Fahrenheit
- TypePipes, Valves & Fittings
- PVC construction resists corrosion in water systems
- FKM gasket handles 40 to 140 Degrees F
- 150 psi rating suits high-pressure tanks
- Socket ends allow solvent-weld pipe connections
- Fits 1-1/2 inch openings on curved or flat tanks
Tank Fitting for PVC Systems
This Hayward Flow Control bulkhead fitting connects pipework through tank walls using a 1-1/2 inch socket on both sides. The PVC body and FKM gasket handle liquids up to 150 psi and temperatures between 40 and 140 Degrees F. It suits curved or flat tank surfaces without bolt holes.
For Plumbing Installers Not Gas Lines
Installers joining PVC pipe to a tank bulkhead will find the socket connections straightforward. The FKM seal resists many chemicals but is not rated for steam or extreme heat. Anyone needing a flanged, threaded or metal-body fitting should look at alternative designs.
150 psi Pressure Rating Decides Fit
The maximum operating pressure of 150 psi is the single figure that determines whether this fitting matches the system design. Exceeding that limit risks joint failure. Confirm the service pressure before specifying this part.
Highlights
- PVC construction resists corrosion in water systems
- FKM gasket handles 40 to 140 Degrees F
- 150 psi rating suits high-pressure tanks
- Socket ends allow solvent-weld pipe connections
- Fits 1-1/2 inch openings on curved or flat tanks
Specifications
| Brand | HAYWARD FLOW CONTROL |
|---|---|
| Type | Pipes, Valves & Fittings |
Questions about this item
How much heat can the PVC body and FKM gasket take during continuous use?
The fitting is rated for a maximum operating temperature of 140 Degrees F and a minimum of 40 Degrees F, so it handles typical hot-water loops within that range.
What pipe or adapter do I need to connect to the 1-1/2 inch socket ends?
Both the inside and outside connections are 1-1/2 inch female sockets, so you solvent-weld standard 1-1/2 inch PVC pipe or a male adapter into each side.
Will the 150 psi pressure rating hold on an older tank with thinner walls?
The bulkhead itself is rated to 150 psi; ensure the tank wall thickness and material can support that pressure at the 1-1/2 inch cut-out before installation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
