We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Hakko desoldering tweezer tip flat blade 1.0mm T9-L1 FM-2023

Hakko

Hakko Desoldering Tweezer Tip Flat Blade 1.0mm T9-L1 FM-2023

SKU CH-FQSV-SKH0N

Flat-blade desoldering tweezer tip with a 1.0 mm chisel for Hakko FM-2023 handpiece on FM-203 and FM-206 stations up to 400 °C

  • TypeSolders & Supplies
  • Size/Dimensions1mm
  • MaterialHAWA
  • Flat 1.0 mm blade removes solder from tight pads
  • Chisel profile delivers focused heat for clean desoldering
  • Works with FM-2023 handpiece on FM-203 and FM-206 stations
  • Operates up to 400 °C for lead-free alloys
  • HAWA material resists erosion during repeated cycles

Compatible tip for FM-2023 handpiece

This Hakko desoldering tweezer tip fits the FM-2023 handpiece and works with FM-203 and FM-206 stations. The flat blade measures 1.0 mm in width and outside diameter. It is made from HAWA material and rated for a maximum operating temperature of 400 degrees C.

Chisel profile aids component removal

The chisel-shaped tip concentrates heat on both leads of a surface-mount device at once. This lets you lift the part cleanly without bending pads or overheating adjacent joints. The 1.0 mm blade suits fine-pitch ICs and small discrete components.

Verify station and handpiece match

Confirm your station is an FM-203 or FM-206 and that the handpiece is an FM-2023 before ordering. This tip will not fit other Hakko handpiece models or stations outside the listed series. Buyers needing a different blade width or tip geometry should select another part number.

Highlights

  • Flat 1.0 mm blade removes solder from tight pads
  • Chisel profile delivers focused heat for clean desoldering
  • Works with FM-2023 handpiece on FM-203 and FM-206 stations
  • Operates up to 400 °C for lead-free alloys
  • HAWA material resists erosion during repeated cycles

Specifications

BrandHakko
TypeSolders & Supplies
Size/Dimensions1mm
MaterialHAWA

Questions about this item

How often will the 1.0 mm flat blade tip need replacing under regular desoldering work?

The tip is a consumable; lifespan depends on temperature cycles and flux type, so plan to replace it when the plating wears or the chisel edge no longer wets cleanly.

What temperature ceiling limits continuous operation on the FM-2023 handpiece?

The tip is rated for a maximum operating temperature of 400 °C; sustained use at that level will trigger the station’s thermal protection first.

How much heat does the tip add to the work area during all-day desoldering on an FM-203 or FM-206 station?

At 400 °C the tip delivers concentrated heat to the joint, but the station’s idle setback and the handpiece’s low mass keep ambient rise minimal during extended sessions.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.