Gytovvvz DC 5.5x2.1mm Power Extension Cord 18AWG 30cm 10A 12V Switch 2 Pack
A 30 cm DC power extension with a 5.5×2.1 mm male-to-female connector, 18 AWG wire rated for 10 A at 12 V, and an inline on/off switch for convenient power control
- TypeOthers
- Length300 millimeters
- Connector Detail5.5*2.1, Male-to-Female
- Terminal GenderMale to Female
- ShieldingWith Switch
- FeaturesWith Switch
- Inline on/off switch lets you cut power without unplugging
- 18 AWG wire handles 10 A at 12 V reliably
- 5 mm × 2.1 mm male-to-female fits standard DC jacks
- 30 cm length keeps cable runs short and tidy
- Two-pack gives a spare for a second device
5.5×2.1 mm DC power extension with inline switch
This pair of 30 cm cords extends a 12 V DC supply using a standard 5.5 mm by 2.1 mm male-to-female connector. Each cable is built from 18 AWG wire rated for 10 A at 12 V. They suit installers and hobbyists who need a quick way to add reach and on-off control to CCTV cameras, LED strips or similar low-voltage devices.
Inline on-off switch replaces repeated plugging
The integrated switch sits along the cable so power can be cut without unplugging the barrel jack. This reduces wear on device ports and speeds up testing or temporary shutdowns during installation. No cutting, soldering or extra tools are required — just connect the male end to the supply and the female end to the load.
Plug-and-play fit for 5.5×2.1 mm jacks only
Installation is straightforward: verify the jack measures 5.5 mm outer and 2.1 mm inner diameter, then push both connectors until seated. The 300 mm length limits routing flexibility in larger enclosures, and the 10 A rating means the cords must not be used on loads that exceed this current at 12 V.
Highlights
- Inline on/off switch lets you cut power without unplugging
- 18 AWG wire handles 10 A at 12 V reliably
- 5 mm × 2.1 mm male-to-female fits standard DC jacks
- 30 cm length keeps cable runs short and tidy
- Two-pack gives a spare for a second device
Specifications
| Brand | Gytovvvz |
|---|---|
| Type | Others |
| Length | 300 millimeters |
| Connector Detail | 5.5*2.1, Male-to-Female |
| Terminal Gender | Male to Female |
| Shielding | With Switch |
| Features | With Switch |
| Disclaimer | other |
Questions about this item
Will the inline switch on this 5.5×2.1 mm cable wear out from daily on/off cycles?
The switch is rated for the cable’s 10 A at 12 V load; normal daily use stays well within that rating, so no scheduled replacement is needed.
What stops me from running this 18 AWG lead at its full 10 A continuously?
The 18 AWG conductors and the inline switch are both specified for 10 A at 12 V, so the cable’s own rating is the first limit reached under sustained load.
Does the switch or the 30 cm wire get noticeably warm when powering a 12 V LED strip all day?
At or below the 10 A, 12 V rating the 18 AWG wire and switch run cool; only loads approaching the maximum rating produce detectable warmth.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



