GSM Outdoors
GSM Outdoors 2 in 1 accessory 7-Pin to LANC 2.5mm D-Tap 60CM
A 60 cm Y-cable links ARRI or cmotion cPRO lens motors to LANC ports on cameras such as the Canon C500, C300 or Sony FX9 while drawing power from a D-Tap source
- Connects ARRI/cPRO lens motors to LANC cameras via 7-pin and 2.5mm ports
- Powers motors from D-Tap sources using the integrated male connector
- Enables run/stop and tally control from electronic hand units
- 60 cm Y-cable layout keeps rigging tidy on set
- Compatible with Canon C500, C300 and Sony FX9 LANC ports
Cable purpose and compatibility
This Y-cable connects an ARRI cforce RF or cmotion cPRO lens motor to the LANC port on cameras such as the Canon C500, C300 and Sony FX9 while simultaneously drawing power from a D-Tap source. It enables camera run/stop and tally functions via an electronic-control hand unit. The 7-pin male connector plugs into the motor, the 2.5 mm LANC plug goes to the camera and the D-Tap male connector attaches to a compatible power supply.
Who should use this and who should not
The cable suits operators using ARRI or cmotion motor systems with the listed camera bodies and a D-Tap power infrastructure. It is not for users whose cameras lack a LANC 2.5 mm port or who power accessories through a different connector type. It also does not serve setups that require a different motor connector or a longer cable run without ordering a custom length.
Check your setup before ordering
Verify that your camera provides a LANC 2.5 mm jack and that your motor uses the 7-pin interface described. Confirm your power source has a D-Tap receptacle and can supply the motor’s voltage and current requirements. Ensure the 60 cm length reaches between your motor, camera and power source in your rig configuration.
Highlights
- Connects ARRI/cPRO lens motors to LANC cameras via 7-pin and 2.5mm ports
- Powers motors from D-Tap sources using the integrated male connector
- Enables run/stop and tally control from electronic hand units
- 60 cm Y-cable layout keeps rigging tidy on set
- Compatible with Canon C500, C300 and Sony FX9 LANC ports
Specifications
No published specifications for this item yet.
Questions about this item
What camera and motor must I already own to use this 7-pin to LANC and D-Tap cable?
You need a camera with a LANC 2.5 mm port such as a Canon C300 or C500 or Sony FX9, plus an ARRI cforce RF or cmotion cPRO lens motor that uses a 7-pin connector.
Will this Y-cable work with my older ARRI or cmotion hand unit that only has a 7-pin motor port?
Yes, the 7-pin male plug connects directly to the motor port on your existing ARRI or cmotion cPRO hand unit, letting you keep that controller.
How can I confirm the cable is powering the motor and triggering run/stop correctly after I connect it?
The motor should initialise and the camera tally light should respond when you press run/stop on the hand unit, showing both power and LANC control are active.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
