Grote
Grote 55420 Stop/Turn/Tail Light Square Red Amber
Square combination stop, turn and tail light with red and amber lenses, incandescent technology and stud surface mount
- Combines stop, turn and tail functions in one square lens
- Red and amber lenses meet rear lighting requirements
- Incandescent source delivers 0.66 to 2.1 A current draw
- Stud mount enables direct surface installation
- Pigtail connection simplifies wiring to vehicle harness
Grote 55420 stop/turn/tail light
The Grote 55420 is a square combination lamp that integrates stop, turn and tail functions in a single housing. It uses incandescent technology with red and amber lenses and mounts on a stud for surface installation. A pigtail provides the electrical connection and the unit draws between .66 and 2.1 A during operation.
Fleets and repair shops needing a direct replacement
This light suits maintenance teams that require a stud-mounted, square stop/turn/tail unit with a pigtail connection. It is not intended for buyers who need a round housing, LED illumination or a different mounting style such as flange or grommet.
Current draw .66 to 2.1 A
The operating current range of .66 to 2.1 A is the key figure for confirming that the vehicle circuit and fuse rating can support the lamp. Match this specification to the wiring harness before installation.
Highlights
- Combines stop, turn and tail functions in one square lens
- Red and amber lenses meet rear lighting requirements
- Incandescent source delivers 0.66 to 2.1 A current draw
- Stud mount enables direct surface installation
- Pigtail connection simplifies wiring to vehicle harness
Specifications
| Brand | GROTE |
|---|
Questions about this item
What current must my vehicle circuit supply for this Grote 55420 light?
The unit draws 0.66 to 2.1 A, so your circuit and fuse must handle at least 2.1 A continuously.
Will the 3/4-inch stud mounting holes on this square light line up with my existing bracket?
The light uses a stud mount for surface installation; verify your bracket hole spacing matches the 4 3/4 in height and 4 9/16 in width before fitting.
How do I confirm the stop, turn and tail functions all work after wiring the pigtail?
Apply power to each pigtail lead in turn — tail should glow red at low current, stop and turn should brighten to 2.1 A and the amber segment should flash for turn.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



