We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square red stop turn tail light with clear lens and stud mount

Grote

Grote 52912 Stop/Turn/Tail Light Square Red 5-3/4" machine shop hardware

SKU CH-WDCM-VZDKB

A square, incandescent stop/turn/tail light with a red lens and stud-mount surface installation

  • Square stop/turn/tail light fits tight spaces
  • Incandescent combo lamp meets DOT lighting requirements
  • Stud-mount design installs fast on flat surfaces
  • Low 0.6 to 2.1 A draw protects vehicle wiring
  • Durable 5-3/4 inch lens resists road vibration

Grote 52912 Stop/Turn/Tail Light

The Grote 52912 is a square combination lamp that integrates stop, turn and tail functions in a single housing. It is designed for vehicles and equipment that require a surface-mounted lighting unit with a clear lens and red output.

Incandescent lighting at .6 to 2.1 A

The incandescent light source draws between .6 and 2.1 amperes depending on which circuit is active. This current range suits standard 12-volt vehicle electrical systems and provides adequate illumination for rear signalling duties.

Surface stud mount with post terminals

The lamp secures to a flat panel through a stud mounting arrangement and connects via electrical posts. The 5-3/4 inch width and 2-7/8 inch depth allow installation on vertical or horizontal surfaces where a compact square profile is preferred.

Highlights

  • Square stop/turn/tail light fits tight spaces
  • Incandescent combo lamp meets DOT lighting requirements
  • Stud-mount design installs fast on flat surfaces
  • Low 0.6 to 2.1 A draw protects vehicle wiring
  • Durable 5-3/4 inch lens resists road vibration

Specifications

BrandGROTE

Questions about this item

Will the 0.6 to 2.1 A draw work with my existing 12 V wiring?

The light draws between 0.6 and 2.1 amps, so standard 12 V automotive circuits and fuse ratings will support it without modification.

How can I verify the stop, turn and tail functions are all working after I mount it?

Apply the brakes, activate each turn signal and switch on the running lights; each mode should illuminate the corresponding red lens section.

Does the 52912 come with a pigtail or connector, or must I buy one separately?

The unit has post terminals only; a mating connector or pigtail is not included and must be sourced separately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.