We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Greenlee 724 stud punch with steel handle and rubber grips

Greenlee

Greenlee 724 Stud Punch hand tool 20 ga

SKU CH-KCEN-CA99M MPN 724

Hand-held stud punch manually forms 1-1/4" holes and rolls edges in 20 ga steel studs

  • TypeHand Held Punches
  • Punches 1-1/4" holes with rolled edges for clean wiring paths
  • Handles 20 ga steel studs for vehicle, equipment or home installs
  • Steel handle with rubber grips reduces fatigue during repeated use
  • Hand-held manual operation needs no power source or setup time
  • Model 724 from Greenlee built for professional stud-punching tasks

Hand-held stud punch for 20-gauge steel

The Greenlee 724 is a manual hand tool that punches 1-1/4 inch holes in 20-gauge steel studs and rolls the edges over in one action. A steel handle with rubber grips provides comfort and control during repetitive use. It is built for electricians and installers running cable through metal framing in vehicles, equipment or buildings. California Proposition 65 warnings apply for cancer and reproductive harm.

Suited for occasional or daily stud punching.

This tool suits tradespeople who need clean, rolled-edge holes in standard 20-gauge studs without switching to a hydraulic or battery-powered driver. It will not punch heavier gauges or larger diameters, so fabricators working with thicker structural steel should look at a different solution.

20-gauge stud capacity

The single specification that decides fit is the 20-gauge steel stud rating. If the framing uses a heavier gauge, the punch cannot penetrate or roll the edge cleanly, and a more powerful tool is required.

Highlights

  • Punches 1-1/4" holes with rolled edges for clean wiring paths
  • Handles 20 ga steel studs for vehicle, equipment or home installs
  • Steel handle with rubber grips reduces fatigue during repeated use
  • Hand-held manual operation needs no power source or setup time
  • Model 724 from Greenlee built for professional stud-punching tasks

Specifications

BrandGreenlee
Model724
TypeHand Held Punches

Questions about this item

How do I verify the Greenlee 724 punches clean 20 ga stud holes after setup?

Test the tool on a scrap piece of 20 ga steel stud; a clean 1-1/4" hole with smoothly rolled edges and no tearing confirms the punch is aligned and working as intended.

What comes in the box with the Greenlee 724 and what must I supply separately?

The box contains the Greenlee 724 stud punch with its steel handle and rubber grips; you will need to provide the 20 ga steel studs and any personal protective equipment you prefer.

Which Greenlee 724 version should I choose for 20 ga steel studs?

The Greenlee 724 model 724 is the single version listed and is rated for 20 ga steel stud capacity, so select this model for that material thickness.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.