Goldwood Sound, Inc.
Goldwood Sound GW-208/4 8" PA speaker 4ohm 4-pack
Four 8-inch PA woofers rated at 100 watts RMS with 4-ohm impedance and 88 dB sensitivity
- TypeSpeaker
- 100W RMS power handles demanding PA sets
- 200W peak capacity absorbs sudden transients cleanly
- 45–7000Hz response covers vocals and midrange
- 88dB sensitivity yields loud output from modest amps
- Four 8in drivers with 1.5in voice coils in one pack
Eight-inch woofers for PA replacement
This four-pack supplies 8" woofers rated at 100 watts RMS and 200 watts maximum each. They suit DJ, karaoke, live-sound, fixed-installation, studio-monitor and home-audio cabinets that need 4-ohm drivers. The poly-laminated cones with rolled foam surrounds handle 45 to 7000Hz response at 88 dB SPL.
Check enclosure cut-out and wiring
Verify each cabinet has a 7.2" mounting hole and at least 3.36" depth behind the baffle. Confirm your amplifier or crossover is stable at 4 ohms per driver and can deliver up to 200 watts peak per channel. Ensure the existing wiring polarity matches the speaker terminals before soldering.
Stamped steel frames with vented magnets
Stamped steel baskets and 20 oz magnets with bumper plates and vented pole pieces dissipate heat during extended sets. The 1.5" aluminum voice coils resist thermal compression. Rolled foam surrounds reduce edge diffraction while surviving repeated high-excursion cycles in professional environments.
Highlights
- 100W RMS power handles demanding PA sets
- 200W peak capacity absorbs sudden transients cleanly
- 45–7000Hz response covers vocals and midrange
- 88dB sensitivity yields loud output from modest amps
- Four 8in drivers with 1.5in voice coils in one pack
Specifications
| Brand | Goldwood |
|---|---|
| Type | Speaker |
Questions about this item
Does the four-pack include any crossover components or mounting hardware?
The listing covers four GW-208/4 woofers only; crossovers, cabinets and mounting screws are not included.
Should I pick the 4-ohm or an 8-ohm version for my amplifier?
These woofers are 4-ohm only; match them to an amplifier rated for 4-ohm loads and 100 W RMS per channel.
What does the 200 W max rating mean when the speakers are installed in a cabinet?
200 W is the short-term peak limit; continuous power should stay near the 100 W RMS figure to avoid thermal damage.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



