Goldwood Sound, Inc.
Goldwood Sound GT-525 Silk Dome Tweeters 40 Pack 200W 8ohm
A pack of 40 silk-dome tweeters rated at 100 W RMS, 200 W peak, 8 Ω impedance and 92 dB sensitivity from 3000 to 18000 Hz
- TypeSpeaker
- 40 tweeters per pack simplify large installs
- 92 dB SPL delivers clear highs at moderate power
- 100 W RMS handles continuous pro-audio demand
- Silk dome cones produce smooth treble response
- 375" cutout fits standard speaker cabinets
40 Silk Dome Tweeters for Pro Audio
This pack supplies forty Goldwood Sound GT-525 tweeters rated at 100 watts RMS and 200 watts maximum each. They cover a frequency response of 3000 to 18000 Hz at 92 dB SPL. The 8 ohm impedance suits standard pro audio crossovers. Designed for DJ, PA, karaoke, live sound, fixed installation, studio monitor and home audio use.
1 inch Voice Coils and 8oz Magnets
Each unit uses a 1 inch voice coil and an 8oz magnet beneath a silk dome cone. The overall diameter is 4.07 inches and the mounting depth is .98 inches. They fit a 3.375 inch enclosure hole for straightforward replacement or new cabinet builds. Engineered in the USA with a lifetime warranty against manufacturer defects.
Efficient High Frequency Output
The 92 dB sensitivity delivers strong output with modest amplifier power. Silk dome construction provides smooth dispersion without the harshness of metal domes. Low mounting depth keeps cabinet profiles shallow. The 8 ohm load presents an easy load for most amplifiers in normal use.
Highlights
- 40 tweeters per pack simplify large installs
- 92 dB SPL delivers clear highs at moderate power
- 100 W RMS handles continuous pro-audio demand
- Silk dome cones produce smooth treble response
- 375" cutout fits standard speaker cabinets
Specifications
| Brand | Goldwood |
|---|---|
| Type | Speaker |
Questions about this item
What frequency range does the 1‑inch silk dome actually cover?
The tweeter reproduces 3000 to 18000 Hz, so it handles the upper midrange and treble but does not extend into deep bass.
What cut‑out diameter and mounting depth are required for each unit?
Each tweeter needs a 3.375‑inch hole and 0.98 inches of clearance behind the panel to sit flush.
How are the 40 tweeters wired to present an 8‑ohm load to the amplifier?
Wire the drivers in series‑parallel groups so the combined impedance stays at 8 ohms; connect positive to positive and negative to negative within each group, then link the groups to the amp terminals.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



