We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Compact rectangular electronic ballast with side wire leads

GE Lighting

GE Lighting 93099521 LED-ET8/DR/2L/H ballast 120-277V 60 Hz

SKU CH-CDSP-EY6QD

Electronic ballast operates two LED T8 lamps at 120-277 V 60 Hz UL Type A

  • Drives two LED lamps on a single driver
  • Operates from 120 V to 277 V input
  • 60 Hz frequency matches standard mains supply
  • UL Type A certification for direct ballast replacement
  • New GE Lighting unit ready for installation

GE Lighting 120-277V LED Driver

The GE 93099521 is a new ballast designed to operate two UL Type A LED lamps. It accepts a 120-277V input at 60 Hz for standard North American mains supply. The unit serves as a direct replacement driver for compatible linear LED tubes.

Suitable for two-lamp Type A retrofits

This driver suits installers converting existing fluorescent fixtures to LED where the tubes require a ballast-compatible Type A driver. It is not for single-lamp fixtures, nor for Type B or Type C LED tubes that need line voltage or an external driver. Builders needing dimming control should verify compatibility separately.

120-277V 60 Hz input range

The deciding specification is the 120-277V 60 Hz input range, which must match the site voltage and frequency. Confirm the fixture wiring and lamp type are UL Type A before purchase. An incorrect voltage or lamp type will prevent operation.

Highlights

  • Drives two LED lamps on a single driver
  • Operates from 120 V to 277 V input
  • 60 Hz frequency matches standard mains supply
  • UL Type A certification for direct ballast replacement
  • New GE Lighting unit ready for installation

Specifications

BrandGE

Questions about this item

What voltage range does the 93099521 ballast need to operate?

The driver runs on 120-277 V at 60 Hz, so it accepts standard North American line voltages without a separate transformer.

How do I wire the LED-ET8/DR/2L/H for a two-lamp retrofit?

Disconnect power, remove the old ballast, connect the driver’s input leads to line and neutral, then attach the two lamp sockets to the output leads following the UL Type A wiring diagram.

When should I plan to replace the 93099521 driver?

Replace the unit if the LED lamps flicker, fail to start, or if the driver enclosure shows heat discoloration after the rated service life of the installed lamps.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.