GE Lighting
GE Lighting 24931 Proline500 130V 500W 10300lm R7S 6-pack
Six 500-watt halogen lamps deliver 10300 lumens each on a 130-volt R7S base
- Selling Unit6
- TypeHalogen Bulbs
- Item Count6
- High 10300 lumen output from 500 watt halogen lamps
- 130 volt operation suits standard mains supplies
- R7S double-ended base fits compatible fixtures directly
- Six-lamp pack provides multiple replacements in one purchase
- GE Proline500 series built for home, apartment and office use
Home, apartment and office lighting
These GE Proline500 halogen lamps deliver 10300 lumen output at 130 volts for general illumination in residential and commercial spaces. The pack contains six 500-watt bulbs with an R7S base for fixtures that accept double-ended quartz tubes. Each lamp is rated for standard line-voltage operation without external ballast.
Replaces lower-output R7S halogen tubes
If existing fixtures use lower-wattage R7S lamps and the circuit supports 500 watts per socket, these bulbs provide a direct increase in lumen output. The jump is worthwhile when rooms require higher brightness levels for task lighting, display areas or large open-plan spaces where fewer fixtures are preferred.
Sustained output at rated voltage
Operating at 130 volts, the quartz envelope maintains stable lumen output over the rated life without the initial spike and rapid decay seen in some lower-voltage designs. The halogen cycle redeposits tungsten on the filament, keeping light output consistent during extended daily use in offices or common areas.
Highlights
- High 10300 lumen output from 500 watt halogen lamps
- 130 volt operation suits standard mains supplies
- R7S double-ended base fits compatible fixtures directly
- Six-lamp pack provides multiple replacements in one purchase
- GE Proline500 series built for home, apartment and office use
Specifications
| Selling Unit | 6 |
|---|---|
| Brand | GE |
| Type | Halogen Bulbs |
| Item Count | 6 |
Questions about this item
What length R7s fixture will accept the 500 W T3 quartz lamp?
The lamp uses a standard R7s double-ended base; check your fixture for a linear T3 quartz socket rated for 500 W at 130 V before fitting.
How should I handle the quartz envelope when inserting the bulb into the R7s holder?
Wear clean gloves or use a cloth to avoid skin oils on the quartz; seat both ends firmly into the spring-loaded contacts so the filament sits centred.
When will the 10 300 lumen output drop enough to need replacement?
Halogen output declines gradually; replace the lamp once light level falls below the task requirement or the filament shows visible darkening.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



