We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green rectangular circuit board with silver finned heatsink, screw terminals and adjustment pots

GCON

GCON DC-DC Boost Converter 600W 10-60V to 12-80V

SKU CH-28AY-NJ7Z3

A 600W DC-DC boost converter steps 10-60V input up to an adjustable 12-80V output with constant voltage and current control

  • 600W high-power boost for demanding voltage step-up
  • Wide 10-60V input accepts varied DC sources
  • Adjustable 12-80V output fits diverse load requirements
  • Integrated 5mm radiator with 21mm fins enables sustained operation
  • Constant voltage and current modes with independent adjustment

DC-DC Boost Converter 600W

The GCON DC-DC Boost Converter is a 600W high-power step-up module that accepts a wide input range of 10V to 60V and delivers an adjustable output of 12V to 80V. It features integrated constant voltage and constant current functions in a non-isolated topology, with the radiator and booster plate combined into a single unit for direct mounting.

Installation requirements

Before ordering, verify that your source can supply a stable input voltage within the 10V to 60V window and that it will not sag below 10V under load, as low-voltage drops can damage the power devices. The module must be powered on before the load is connected, and multiple units cannot be paralleled on either the input or output side.

Thermals, noise and power

The integrated radiator uses a 5mm base plate with 21mm fin height across an 85mm by 63mm footprint to dissipate heat from the booster plate mounted directly above it. No fan is included, so cooling relies on natural convection and the mounting surface; audible noise is limited to coil behaviour under load, and the unit draws up to 600W from the source depending on the configured output voltage and current.

Highlights

  • 600W high-power boost for demanding voltage step-up
  • Wide 10-60V input accepts varied DC sources
  • Adjustable 12-80V output fits diverse load requirements
  • Integrated 5mm radiator with 21mm fins enables sustained operation
  • Constant voltage and current modes with independent adjustment

Specifications

No published specifications for this item yet.

Questions about this item

What comes with the GCON boost converter and what must I source separately?

The module arrives as an assembled board with integrated heatsink measuring 85 mm by 63 mm; you must supply your own DC power source within the 10 V to 60 V input range, wiring, and mounting hardware.

How do I decide between the 10 V to 60 V input range and the 12 V to 80 V output range for my application?

Choose an input source that stays between 10 V and 60 V, then set the output voltage anywhere from 12 V to 80 V to match your load; the converter only boosts, so output must be higher than input.

What does the 600 W rating mean when the converter is installed in a system?

It indicates the maximum continuous power the board can deliver when input voltage, output voltage, and cooling allow; actual usable power depends on the specific input-output combination and thermal conditions.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.