We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two gray foam conduit pistons, 6.25 in long, hook-and-loop closure

Gardner Bender

Gardner Bender FC12 Conduit Piston 6.25 in PK2

SKU CH-RFSY-V062T

A foam conduit piston set pulls cable through 6 in EMT, flexible, IMC, PVC or rigid conduit and includes two carriers

  • Type3" Harsh Environment, Hook-and-Loop Closure
  • ColorGray
  • Pulls cable through 6 in conduit with 6.25 in foam piston
  • Two carriers included for immediate multi-run jobs
  • Works with EMT, Flexible, IMC, PVC and Rigid conduit
  • Compatible with Gardner Bender B60, BV208DA and JO225LC blowers
  • Gray foam body resists harsh site conditions

Gardner Bender FC12 Conduit Piston

The Gardner Bender FC12 is a foam conduit piston designed to pull cable through EMT, flexible, IMC, PVC, and rigid conduit with a 6 in trade size. Each package contains two carriers with an overall length of 6.25 in and overall width of 6.3 in. It connects to compatible Gardner Bender blower or vacuum units for cable installation.

Installers pulling wire through 6 in conduit

This piston suits electricians and low-voltage installers who need to pull cable through 6 in EMT, IMC, PVC, rigid, or flexible conduit using a Gardner Bender blower or vacuum. It is not intended for smaller conduit sizes or for use with blowers and vacuums outside the compatible Gardner Bender series.

6 in compatible conduit size

The single specification that determines fit is the 6 in compatible conduit size. The foam carriers measure 6.25 in overall length and 6.3 in overall width to match that conduit trade size. Verify your conduit size and blower or vacuum model against the compatible list before ordering.

Highlights

  • Pulls cable through 6 in conduit with 6.25 in foam piston
  • Two carriers included for immediate multi-run jobs
  • Works with EMT, Flexible, IMC, PVC and Rigid conduit
  • Compatible with Gardner Bender B60, BV208DA and JO225LC blowers
  • Gray foam body resists harsh site conditions

Specifications

BrandGardner Bender
ModelFC12
Type3" Harsh Environment, Hook-and-Loop Closure
ColorGray

Questions about this item

How do I install the Gardner Bender FC12 conduit piston, and what step is often missed?

Insert the 6.25 in foam piston into the 6 in compatible conduit, attach it to a Gardner Bender B60, BV208DA or JO225LC blower/vacuum, then start the airflow; the step often missed is confirming the hook-and-loop carrier is fully seated before switching on.

What maintenance or replacement will the FC12 piston need later?

The foam piston and its two hook-and-loop carriers are consumables; replace them when the foam shows compression set or the closure no longer grips the conduit wall during pulling jobs.

What limit appears first when the FC12 piston is used continuously?

The 6.3 in overall width and foam material set the practical limit; sustained high-velocity airflow can over-compress the piston, reducing seal effectiveness in EMT, flexible, IMC, PVC or rigid conduit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.