We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Formulamod Fm-NCK1-300 18AWG ATX 24P EPS 8P PCIe 8P Blue 300mm

SKU CH-BJ5K-683T4

A 300 mm sleeved extension kit with 24-pin ATX, 8-pin EPS and two 8-pin PCIe connectors in blue, using 18AWG wire and pre-bent 180° for tidy routing

  • TypePCIe, ATX
  • ColorBlue
  • Lengthmillimeters 300
  • Cable Length300 millimeters
  • SpeedPremium Sleeved & Customizable
  • SpecificationsFm-NCK1-300, PCIe, ATX, blue, Formulamod
  • Complete kit with 24-pin ATX, 8-pin EPS and dual 8-pin PCIe
  • Thick 18AWG conductors deliver stable power to every component
  • High-density flexible sleeve protects wires while keeping routing clean
  • Pre-bent 180° design keeps cables neat after sharp turns
  • Heat-shrink-less construction removes bulk for easier cable management

Cable kit contents

The Formulamod Fm-NCK1-300 kit includes one 24-pin ATX cable, one 4+4-pin EPS cable and two 8-pin PCIe cables. Each cable measures 300 millimetres and uses 18AWG conductors wrapped in a high-density nylon sleeve. Cable combs are supplied for clean routing. The male-to-female connectors extend existing power-supply leads.

Capacity and headroom

Thick 18AWG wiring delivers ample current for mainstream desktop builds and typical graphics cards. The 300-millimetre length suits mid-tower cases but may fall short in larger chassis or when routing behind motherboard trays. Pre-bent 180-degree ends keep cables tidy only when the retention buckle faces the documented direction.

Upgrade path and fit

This set replaces stock sleeveless cables for builders who want a uniform blue appearance without full custom sleeving. It is not suited for systems requiring longer runs, additional EPS or PCIe connectors, or configurations where the buckle orientation contradicts the pre-bend design.

Highlights

  • Complete kit with 24-pin ATX, 8-pin EPS and dual 8-pin PCIe
  • Thick 18AWG conductors deliver stable power to every component
  • High-density flexible sleeve protects wires while keeping routing clean
  • Pre-bent 180° design keeps cables neat after sharp turns
  • Heat-shrink-less construction removes bulk for easier cable management

Specifications

BrandFormulamod
ModelFm-NCK1-300
TypePCIe, ATX
ColorBlue
Lengthmillimeters 300
Cable Length300 millimeters
SpeedPremium Sleeved & Customizable
SpecificationsFm-NCK1-300, PCIe, ATX, blue, Formulamod
Sports Team1 Piece
Connector DetailPCIe, ATX
Terminal GenderMale to Female
ShieldingPremium Sleeved & Customizable
ConstructionNylon or similar synthetic material
Refresh Rate300 ± 10 mm
FeaturesPCIe, ATX, blue, Formulamod, Fm-NCK1-300

Questions about this item

Will the 300 mm blue extensions reach cleanly from a bottom-mounted PSU to an older ATX 24-pin motherboard header?

Each cable measures 300 mm and uses 18 AWG wire inside a flexible sleeve, so the kit spans the distance from a floor-mounted supply to the 24-pin board connector without strain.

How can I confirm the pre-bent 180° routing is seated correctly after installation?

Align every connector so the latch tab faces the direction shown in the guide — ATX and EPS bends toward the tab, PCIe bends away — then verify all 24, 8 and 8-pin plugs click fully home.

Does the package include combs for the two PCIe 8-pin cables as well as the ATX and EPS leads?

Yes, the kit supplies one 24-pin ATX, one 4+4-pin EPS, two 8-pin PCIe cables and several combs to dress every wire in the set.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.