We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Halogen modeling lamp with E27 screw base 150W

Flashpoint Brand

Flashpoint Modeling Lamp FP620M 150W E27

SKU CH-WDWG-DDYZZ

A 150 W halogen modelling lamp with an E27 Edison base for the FP620M monolight, operating on 110-120 V

  • 150 W halogen output gives bright, consistent modelling light
  • E27 Edison base fits FP620M and other compatible monolights
  • 110–120 V operation suits standard studio power supplies
  • Halogen technology delivers reliable colour quality for accurate previews
  • Spare lamp ensures uninterrupted sessions when the original fails

Modeling lamp for FP620M monolight

The 150W halogen modelling lamp fits the Flashpoint FP620M monolight and uses a standard E27 Edison screw base. It provides continuous illumination so photographers and videographers can preview lighting ratios and focus before firing the flash. The lamp operates on 110-120v mains voltage and is built to match the socket tolerances of Flashpoint, Bowens and Elinchrom heads. It is aimed at studio shooters who need a reliable replacement or spare for their FP620M unit.

Thermals noise and power draw

The lamp consumes 150W at 110-120v and emits the heat typical of a halogen source during modelling sessions. No fan or active cooling is present; the monolight housing manages dissipation passively. Operation is silent because there are no moving parts. Power draw is constant while the modelling lamp is switched on and ceases when the flash fires or the lamp is turned off.

Spare lamp extends session continuity

Keeping an extra E27 modelling lamp on hand prevents downtime if the installed bulb fails mid-shoot. The screw-in design allows tool-free replacement in seconds, so lighting setups stay consistent across long sessions. The halogen spectrum gives a warm, continuous preview that matches the flash colour balance for accurate modelling. No software or firmware is involved; the accessory is a direct hardware spare.

Highlights

  • 150 W halogen output gives bright, consistent modelling light
  • E27 Edison base fits FP620M and other compatible monolights
  • 110–120 V operation suits standard studio power supplies
  • Halogen technology delivers reliable colour quality for accurate previews
  • Spare lamp ensures uninterrupted sessions when the original fails

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the E27 base lamp in the FP620M monolight, and what step is often missed?

Screw the 150W halogen lamp firmly into the E27 socket until seated, then verify the monolight's voltage selector is set to the 110-120v range before powering on.

When will this 150W halogen modeling lamp need replacement?

Halogen lamps typically dim and shift colour temperature after several hundred hours of use; keep a spare FP-ML-620M on hand for immediate swap when output drops.

What limits continuous operation of the 150W modeling lamp in the FP620M?

Sustained use generates significant heat from the 150W halogen filament, so the monolight's thermal protection will cycle the lamp off first to prevent overheating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.