Fervit
Fervit USB 3.1 Type C Female to USB 3.0 19pin Header Cable 40cm
Converts a motherboard 19-pin USB 3.0 header to an external USB-C socket with a 40 cm cable supporting 5 Gbps speeds
- Add a front-panel USB-C port by converting an internal 19-pin header
- 40 cm cable fits tidy routing inside compact cases
- USB 3.0 header delivers up to 5 Gbps throughput
- Female USB-C connector accepts reversible Type-C plugs
- Single-port design keeps the installation simple and clean
Single-port USB 3.1 Type-C adapter for internal
This cable converts a motherboard 19-pin USB 3.0 header into an external USB-C socket. It targets builders adding a front-panel Type-C port to cases that lack one. The 40 cm length suits typical chassis routing. No active electronics are included; the link runs at USB 3.0 speeds.
Sustained 5 Gbps throughput on a passive 40 cm run
The adapter supports USB 3.0 5 Gbps maximum transfer rate across its full length. Because it is a straight-through cable, latency and bandwidth remain stable during long file moves or backups. Thermal throttling does not occur. Performance matches the host controller limits.
Shielded cable with keyed 19-pin plug
The 19-pin connector is keyed to prevent misinsertion on the motherboard header. A standard USB-C female port accepts reversible plugs from any orientation. Builders can mount the jack in a rear bracket or front-panel cut-out. The 40 cm lead reaches most ATX board layouts without strain.
Highlights
- Add a front-panel USB-C port by converting an internal 19-pin header
- 40 cm cable fits tidy routing inside compact cases
- USB 3.0 header delivers up to 5 Gbps throughput
- Female USB-C connector accepts reversible Type-C plugs
- Single-port design keeps the installation simple and clean
Specifications
| Brand | Fervit |
|---|
Questions about this item
Does the cable generate noticeable heat when a device draws the full 5 Gbps bandwidth all day?
The adapter is a passive cable assembly without active electronics, so it does not produce measurable heat during sustained USB 3.0 5Gbps transfers.
What must my motherboard provide for this 19-pin header cable to function?
An available internal USB 3.0 19-pin header on the motherboard is required; the cable simply routes that header to an external USB 3.1 Type-C female port.
Will the 40 cm length reach a front-panel cut-out on a full-tower case with the header near the bottom edge?
At 40 cm the cable spans most mid-tower and many full-tower layouts, but measure your specific header-to-panel distance before ordering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



