We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue USB 3.0 A female port with two screw holes, black 90-degree down-angled 20-pin header, 25cm cable

Fervit

Fervit USB 3.0 A Female Screw Mount to Down Angled 20pin Header Cable 90 Degree 25cm

SKU CH-RBB7-7JCG2

Adds a screw-mount USB 3.0 Type-A port to a motherboard 20-pin header with a 90-degree down-angled connector and 25 cm cable

  • Connect internal 20-pin header to external USB 3.0 port
  • Down-angled 90-degree header fits tight motherboard clearances
  • Screw-mount female socket secures panel installation firmly
  • 25 cm cable length keeps front-panel routing tidy
  • Direct 20-pin to USB 3.0 conversion without adapters

USB 3.0 screw-mount adapter for front-panel builds

This 25 cm cable converts a motherboard 20-pin header into a single USB 3.0 Type-A female port. The down-angled header connector eases routing behind a front panel or drive bay. Two screw holes on the port flange allow a secure panel mount. It suits builders adding a front USB 3.0 port to a case that lacks one.

Check header orientation

Your motherboard must expose a standard 20-pin USB 3.0 header with the correct keying. Verify the down-angled plug will clear nearby components once seated. The mounting holes require a panel thick enough for screws and a cut-out matching the Type-A flange dimensions. No internal drive bay or bracket is included.

Fits tight front-panel spaces and frees rear I/O

The 90-degree header bend keeps the cable close to the board, reducing clutter behind shallow panels. A secure screw mount prevents the port from shifting when devices are plugged or unplugged. Moving one USB 3.0 connection to the front leaves rear ports free for stationary peripherals. The 25 cm length reaches most front-panel locations without excess slack.

Highlights

  • Connect internal 20-pin header to external USB 3.0 port
  • Down-angled 90-degree header fits tight motherboard clearances
  • Screw-mount female socket secures panel installation firmly
  • 25 cm cable length keeps front-panel routing tidy
  • Direct 20-pin to USB 3.0 conversion without adapters

Specifications

BrandFervit

Questions about this item

What connectors and cable length are included, and is any extra hardware required for mounting?

The cable has a down-angled 20-pin motherboard header on one end and a USB 3.0 Type-A female port with two screw holes on the other; the 25 cm cable is the only part supplied, and mounting screws are not included.

This model is listed as a single 25 cm length — how do I decide if that reach is right for my case?

Measure from your motherboard's 20-pin USB 3.0 header to the front-panel cut-out; if the straight-line distance is 25 cm or less, this cable will reach, otherwise you need a longer variant.

What does the USB 3.0 rating actually deliver when the cable is installed in a PC?

The 20-pin header carries the full USB 3.0 signalling, so the front-panel port can run at 5 Gb/s provided the motherboard header and any connected device also support USB 3.0.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.