Fervit
Fervit USB 3.0 20Pin 19Pin Left Angled Male to Female Extension Cable for Mainboard
A 90-degree left-angled USB 3.0 extension cable connects 20-pin or 19-pin motherboard headers at up to 5 Gbps where space is limited
- Super-speed up to 5Gbps, 10 times faster than USB 2.0
- 90-degree angled connector fits tight spaces around the motherboard header
- Male-to-female extension adds reach for 20Pin and 19Pin USB 3.0 headers
- Supports simultaneous two-way data transmission
- Designed for USB 3.0 motherboard or host connections
90° USB 3.0 Internal Extension Cable
This Fervit cable adds a left-angled male-to-female link to a motherboard 20-pin or 19-pin USB 3.0 header. It supports 5 Gbps transfer rates, roughly ten times the throughput of USB 2.0. Full-duplex signalling allows simultaneous two-way data flow. The 90-degree plug fits tight clearances around the header.
For builders with cramped header zones.
Installers routing cables behind large coolers or tight drive cages gain the needed clearance without stressing the header pins. The extension only serves internal 20-pin or 19-pin USB 3.0 headers, so it cannot adapt Type-A, Type-C or USB 2.0 front-panel connectors. Users needing longer reach or straight connectors should choose a different cable.
Check header pin-count and free space before buying
Verify that your motherboard exposes a 20-pin or 19-pin USB 3.0 header and note its keying orientation. Measure the gap between the header and any neighbouring component to confirm the 90-degree bend clears obstructions. Ensure the cable length suits your routing path from header to front-panel or internal device.
Highlights
- Super-speed up to 5Gbps, 10 times faster than USB 2.0
- 90-degree angled connector fits tight spaces around the motherboard header
- Male-to-female extension adds reach for 20Pin and 19Pin USB 3.0 headers
- Supports simultaneous two-way data transmission
- Designed for USB 3.0 motherboard or host connections
Specifications
| Brand | Fervit |
|---|
Questions about this item
Does my motherboard need a 20-pin or 19-pin USB 3.0 header for this cable to plug in?
Yes, the cable is designed for a 20-pin or 19-pin USB 3.0 header on the motherboard or host controller.
Will the 90-degree angled connector still fit if my case front-panel USB 3.0 cable runs tight against the board edge?
The left-angled male end lets you mate the female port even when clearance around the header is limited.
After connecting the cable, how can I confirm the link is running at the full 5 Gbps rate?
Check the OS device manager or a USB topology tool; the port should enumerate as a USB 3.0 connection capable of 5 Gbps.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Tripp Lite U324-003-BK USB 3.0 cable USB-A to USB-A 3 ft
- USB
- Black


