We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green circuit board with one 19/20-pin header, two 19/20-pin sockets and a SATA power connector

Fervit

Fervit USB 3.0 19/20Pin Header to Dual Port Adapter Splitter HUB with SATA Power

SKU CH-1EJ0-9DRBZ

Converts a single motherboard USB 3.0 19/20-pin header into two headers with SATA power for front-panel devices

  • Add two front-panel USB 3.0 ports from one 19/20-pin header
  • Transfer files at up to 5 Gbps with USB 3.0 speed
  • Extra SATA power keeps both ports stable under load
  • Works with front panels, hubs and card readers using 20-pin connectors
  • Plug straight into the motherboard header — no drivers required

Single header to dual USB 3.0 ports

This adapter converts one motherboard USB 3.0 19/20-pin header into two female 19/20-pin connectors. It supports front-panel ports, internal hubs and card readers that use the standard 20-pin interface. The board draws auxiliary power from a SATA connector to run both outputs. It suits builders whose chassis has more front-panel ports than onboard headers.

Powered by SATA for stable operation

The extra SATA power cable supplies the splitter so both downstream headers receive adequate current without overloading the motherboard header. No active cooling or fan is present, so the device runs silently inside the case. Power draw in normal use is limited to the connected peripherals and the adapter's own logic.

Splits one 19/20-pin header into two

The single specification that decides fit is the 1-to-2 header split with SATA auxiliary power. Builders needing to connect three or more internal USB 3.0 devices from one header cannot use this part. Boards lacking a spare SATA power connector are also incompatible.

Highlights

  • Add two front-panel USB 3.0 ports from one 19/20-pin header
  • Transfer files at up to 5 Gbps with USB 3.0 speed
  • Extra SATA power keeps both ports stable under load
  • Works with front panels, hubs and card readers using 20-pin connectors
  • Plug straight into the motherboard header — no drivers required

Specifications

BrandFervit

Questions about this item

How do I connect the Fervit adapter to my motherboard 19/20pin header and where does the SATA power cable plug in?

Plug the single 19/20pin male header into the motherboard USB 3.0 socket, attach the two female 19/20pin headers to your front-panel cables, then connect the extra SATA power lead to a spare SATA power connector from the PSU.

Will the SATA power cable or the adapter PCB need replacement after extended use?

The SATA power cable is a standard passive lead with no moving parts, and the adapter PCB has no active components that wear out; neither item has a scheduled replacement interval.

What bandwidth limit appears first when both 20pin ports run at full 5Gbps simultaneously?

The single 19/20pin host link is capped at 5Gbps total, so combined throughput of both ports cannot exceed that 5Gbps ceiling.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.