We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Fervit SFF-8482 SAS 29-pin to USB 3.0 adapter board with power port

Fervit

Fervit SFF-8482 SAS 29Pin to USB 3.0 5Gbps RAID Adapter

SKU CH-NVTA-QSA9Z

Converts SFF-8482 SAS drives to USB 3.0 at up to 5Gbps with a built-in chip, supporting Windows 7, 10, 11 and Linux while requiring a separate 12V/3A power supply

  • Connect SAS drives via USB without a RAID card
  • 5 Gbps USB 3.0 throughput for fast transfers
  • Works with Windows 7, 10, 11 and Linux
  • Supports SAS/SATA 6.0, 3.0 and 1.5 Gbps drives
  • Requires separate 12 V 3 A DC 5.5 × 2.1 mm power supply

SAS to USB adapter for direct disk access

The Fervit adapter connects a single SFF-8482 SAS drive to a USB 3.0 port, letting desktops or laptops read and write the disk without a dedicated RAID card. It targets technicians and hobbyists who need quick access to enterprise SAS storage on ordinary hardware.

Passive cooling and external 12 V power requirement

The unit has no fan and draws all drive power from a separate 12 V 3 A supply with a 5.5 mm × 2.1 mm barrel plug, which is not included. Under load the adapter runs silently, but the host USB port must deliver 5 Gbps bandwidth for full throughput.

29-pin connector and OS compatibility

The built-in bridge chip handles SAS/SATA 6.0, 3.0 and 1.5 Gbps link speeds and works with Windows 7, 10, 11 and Linux. SMART data may appear incomplete after conversion, while SFF-8639 U.2 drives are not supported, so buyers with those disks need a different solution.

Highlights

  • Connect SAS drives via USB without a RAID card
  • 5 Gbps USB 3.0 throughput for fast transfers
  • Works with Windows 7, 10, 11 and Linux
  • Supports SAS/SATA 6.0, 3.0 and 1.5 Gbps drives
  • Requires separate 12 V 3 A DC 5.5 × 2.1 mm power supply

Specifications

BrandFervit

Questions about this item

How do I install the Fervit SFF-8482 adapter and what step is often missed?

Connect the 29-pin SFF-8482 SAS drive to the adapter, then plug the USB 3.0 end into the host. The step often missed is attaching a separate 12V/3A DC 5.5*2.1mm power supply, which is not included.

What maintenance or replacement will this adapter need later?

The unit has no moving parts or consumable components, so no scheduled maintenance is required. Only the external 12V/3A power supply may need replacement if it fails over time.

What limit appears first under sustained use?

The USB 3.0 interface caps throughput at 5Gbps, which is lower than the SAS/SATA 6.0Gbps link speed the drive can deliver. This bus bottleneck shows up first during long sequential transfers.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.