We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Internal Mini SAS HD SFF-8643 to four SAS 29pin breakout cable 50cm

Fervit

Fervit Mini SAS HD SFF-8643 to 4x SAS 29pin cable 50cm

SKU CH-VSKA-9WMDT

Connects up to four SAS or SATA drives to a Mini SAS HD SFF-8643 controller with a 50cm cable

  • Connect up to 4 SAS or SATA drives
  • 50 cm length fits tight chassis spaces
  • SFF-8643 host to four 29-pin device connectors
  • Meets SAS 2.1 6 Gb/s specification
  • Not compatible with PCI-E SFF-8643 controllers

Connect four drives

This Fervit cable connects up to four SAS or SATA drives to a Mini SAS HD SFF-8643 host port. It serves builders adding internal storage to a compatible controller. The 50cm length suits typical chassis routing. It is not for PCI-E SFF-8643 controllers.

Signal integrity

The cable meets the SAS 2.1 standard at 6Gb/s per lane. Passive wiring keeps power draw at zero and adds no fan noise. Shielded construction preserves signal quality across the 50cm run.

Controller compatibility

The host connector is Mini SAS HD SFF-8643; the device ends are four SAS 29pin ports. PCI-E SFF-8643 controllers are not supported. Verify your controller matches the host interface before purchase.

Highlights

  • Connect up to 4 SAS or SATA drives
  • 50 cm length fits tight chassis spaces
  • SFF-8643 host to four 29-pin device connectors
  • Meets SAS 2.1 6 Gb/s specification
  • Not compatible with PCI-E SFF-8643 controllers

Specifications

BrandFervit

Questions about this item

How do I install the Mini SAS HD SFF-8643 end, and what step is often missed?

Insert the single SFF-8643 connector into the controller until the latch clicks; the step people miss is verifying the latch is fully engaged before routing the four 29-pin tails to the drives.

What maintenance or replacement will this cable need later?

No scheduled maintenance is required; replace the cable only if the SFF-8643 latch breaks, a 29-pin connector is bent, or the 50 cm length becomes too short after a chassis change.

What limit appears first under sustained use with four drives?

The 6 Gb/s SAS 2.1 bandwidth shared across the single SFF-8643 link becomes the bottleneck before the cable itself degrades.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.